Page 12 of 20 FirstFirst ... 21011121314 ... LastLast
Results 111 to 120 of 195

Thread: Now Another Problem.....

  1. #111
    Here for the party Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Canaan NH
    Posts
    1,710
    Thanks
    364
    Thanked 106 Times in 87 Posts
    Sounds like the IAC is not working. At idle, when you turn the wheel or turn the A/C on the idle should increase. If it doesnt then check out the IAC asap, bad ones are well documented as destroying ECUs.

  2. #112
    The idle does increase. I replaced the IAC a couple months ago. I know it's good.

  3. #113
    Here for the party Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Canaan NH
    Posts
    1,710
    Thanks
    364
    Thanked 106 Times in 87 Posts
    Quote Originally Posted by GRSHOPR View Post
    There were 4 pins in each relay, and there was power to all the pins but the middle one in each relay.
    There are 5 spots for pins but only 4 pins correct ? The middle one is pin 4, it is on the switched side of the relay and wouldnt have power without the relay being in and active. You could check that you have a ground at pin 1 of the 6 pin plug at the radiator, should be passenger side of it IIRC. Also the fans wouldnt come on with the A/C unless the A/C works.

  4. #114
    Here for the party Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Canaan NH
    Posts
    1,710
    Thanks
    364
    Thanked 106 Times in 87 Posts
    Quote Originally Posted by GRSHOPR View Post
    The idle does increase. I replaced the IAC a couple months ago. I know it's good.
    Thats good to know.

  5. #115
    Quote Originally Posted by CoreyB View Post
    There are 5 spots for pins but only 4 pins correct ? The middle one is pin 4, it is on the switched side of the relay and wouldnt have power without the relay being in and active. You could check that you have a ground at pin 1 of the 6 pin plug at the radiator, should be passenger side of it IIRC. Also the fans wouldnt come on with the A/C unless the A/C works.
    There are only 4 pins on each relay. And the radiator had a 6 pin connector, but the harness for it didn't (it had 4 pins), so I had to splice in the 4 pin connector, leaving 2 extra wires. These two wires lead to the coolant temp sensors in the radiator. I just don't know where to splice them in for the radiator/ECU.
    Last edited by GRSHOPR; 10-06-2010 at 01:22 PM.

  6. #116
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Bamberg, Germany
    Posts
    604
    Blog Entries
    2
    Thanks
    3
    Thanked 22 Times in 16 Posts
    i read all 12 pages my head hurts and im never doing a TT swap. Nice project you have their, did you make sure to change to the 91 crank angle sensor and not the 93+ Cam angle sensor because you put the ECU from the 91 in it. just thought I would ask

    3000GT of Europe
    www.3sofeu.org/main
    Cherry Hill Mitsubishi Coupon Code- 3SE

  7. #117
    Here for the party Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Canaan NH
    Posts
    1,710
    Thanks
    364
    Thanked 106 Times in 87 Posts
    OK, on the radiator side pin 1 is ground and is the black wire from the harness.
    Last edited by CoreyB; 10-06-2010 at 01:26 PM.

  8. #118
    Quote Originally Posted by ntcmpjg View Post
    i read all 12 pages my head hurts and im never doing a TT swap. Nice project you have their, did you make sure to change to the 91 crank angle sensor and not the 93+ Cam angle sensor because you put the ECU from the 91 in it. just thought I would ask
    The 91 motor came with the proper CAS. I didn't have to touch a thing. The right one is in.

  9. #119
    Here for the party Not Verified
    Join Date
    Sep 2010
    Owner Since
    2006

    Location
    Canaan NH
    Posts
    1,710
    Thanks
    364
    Thanked 106 Times in 87 Posts
    Quote Originally Posted by ntcmpjg View Post
    i read all 12 pages my head hurts and im never doing a TT swap. Nice project you have their, did you make sure to change to the 91 crank angle sensor and not the 93+ Cam angle sensor because you put the ECU from the 91 in it. just thought I would ask
    He has a 91 engine.

  10. #120
    Quote Originally Posted by CoreyB View Post
    OK, on the radiator side pin 1 is ground and is the black wire from the harness.
    OK, so green is ground. Seems standard. But where does the red wire (pin 4) head to? And can I just ground pin 1 straight up, or do I need to ground it to the ECU?
    Last edited by GRSHOPR; 10-06-2010 at 01:31 PM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The 3000GT/Stealth/GTO Web History Project
3000gt.com
3000GT / Stealth International WWWboard Archive
Jim's (RED3KGT) Reststop
3000GT/Stealth/GTO Information and Resources
Team 3S
3000GT / Stealth / GTO Information
daveblack.net
3000GT/Stealth/GTO Clubs and Groups
Michigan 3S
MInnesota 3S
Wisconsin 3S
Iowa, Nebraska, Kansas 3S
North California 3000GT/Stealth
United Society of 3S Owners
3000GT/Stealth/GTO Forums
3000GT/Stealth International
3000GT/Stealth/GTO Event Pages
3S National Gathering
East Coast Gathering
Upper Mid-West Gathering
Blue Ridge Gathering