What did you do today to your 3/S?

[Chris@Rvengeperformance]

I would use back to black


Sent from my DROIDX using Tapatalk 2

[J_Parker]

I would NOT recommend putting that stuff on anything except rubber. It's very greasy and it runs off of painted surfaces.

This, it runs and fouls the surrounding paint, it doesn't look good at all.

[james92tsi]

Today? I looked at her longingly. lol.

Drove her Sunday night, and the clutch started engaging right off the floor. Limped her home and haven't had time to look at it, other than to see if the master cylinder was leaking (it isn't). Might be a failing slave... I'll bleed it and go from there. Have never replaceid/rebuilt either on this car.

Gauge cluster project is coming along. Dashboard might be coming out in the next couple weeks so I can glue the vinyl down around the driver defrost vent prior to installing all that pretty gauge stuff... which coincidentally will be easier to install with the dash out. :P

[AdamVR4]

Today? I looked at her longingly. lol.

Drove her Sunday night, and the clutch started engaging right off the floor. Limped her home and haven't had time to look at it, other than to see if the master cylinder was leaking (it isn't). Might be a failing slave... I'll bleed it and go from there. Have never replaceid/rebuilt either on this car.

Gauge cluster project is coming along. Dashboard might be coming out in the next couple weeks so I can glue the vinyl down around the driver defrost vent prior to installing all that pretty gauge stuff... which coincidentally will be easier to install with the dash out. :P

Replacing the slave is super easy... The master is a bit of a PITA.

[CoopKill]

I would use back to black


Sent from my DROIDX using Tapatalk 2

This is good as well...

[DuTTch]

Today? I looked at her longingly. lol.

Drove her Sunday night, and the clutch started engaging right off the floor. Limped her home and haven't had time to look at it, other than to see if the master cylinder was leaking (it isn't). Might be a failing slave... I'll bleed it and go from there. Have never replaceid/rebuilt either on this car.

Gauge cluster project is coming along. Dashboard might be coming out in the next couple weeks so I can glue the vinyl down around the driver defrost vent prior to installing all that pretty gauge stuff... which coincidentally will be easier to install with the dash out. :P

U gonna make it to the TX gathering?

[J_Parker]

Started sanding/polishing my compressor housings.

[2fnloud]

Had my Azenis tires dismounted of my stock chromies, to put the stockers into storage and I have a sale pending on the tires. All this was done for monies and to make room for my spare transmission that should be here tomorrow.

[Chris@Rvengeperformance]

Had my Azenis tires dismounted of my stock chromies, to put the stockers into storage and I have a sale pending on the tires. All this was done for monies and to make room for my spare transmission that should be here tomorrow.

did the freight guys call you already?

[2fnloud]

yes, yes they did