JimVR4 95 Spyder Engine Rebuild

[DuTTch]

or order the brace from him and have a local shop weld it in!

[Jimvr4]

Yeah, Chargerx3 is telling me to do that too. I'm probably not going to do it as I'm not planning on doing high rpm clutch dumps. Maybe I'll do it later if I decide to make this more of a track car.

[Jimvr4]

Looking good Jim

Thanks! Hope Jack's gets off the dime soon for you!

Meticulous work sir

Looking forward to "ignition"...

Bob.

Yeah, me too! Engine drop in is planned for Saturday

[CoopKill]

You may be making my Mistress jealous!

[Jimvr4]

Mirror mirror on the wall....

[CoopKill]

Yeah, me too! Engine drop in is planned for Saturday

It is after that when the real time is sucked from your existence.

[DrGonzo]

Yeah, me too! Engine drop in is planned for Saturday

Ha, I'm planning on dropping my new engine in this weekend also!!

[Jimvr4]

It is after that when the real time is sucked from your existence.

Man, after 8 months I just wanna master this bitch again! I wanna drive her.

Ha, I'm planning on dropping my new engine in this weekend also!!

Damn, that was fast! Hope you get good weather

[green-lantern]

Looking good Jim, that trans is so clean!

[Jimvr4]

Looking good Jim, that trans is so clean!

If I would have had more time and $$ I would have chromed it lol. Would have needed to press out the input shaft and all the bearings to strip the cases down though. Ray did this in that "Another Pampena big build" thread on the other site.