No. It takes a few seconds to click again.
No. It takes a few seconds to click again.
Gonna have to think about this. Sorry man doing my best here. I would try the holing the contacts shut thing but thats just me. If it does run I still wouldnt know what was causing it to not work properly.
but you could check to see if pin 8 always has power with the key on, even after it stalls. This will tell you its not the power to the MFI but the ECU not supplying the ground or the MFI itself. Have a hard time believing its the MFI though.
Dude, don't be sorry. You're being a huge help. I'll go try holding the contacts together, see what comes of it, and test pin 8 as well. Thanks again for your help!
Check out the diagrams a little further down in this link. What do you make of them?
http://www.3si.org/forum/f103/no-spa...e-help-372620/
That is about the resistor in the fuel pump system. I thought about this earlier but then moved on before mentioning it to you. There is a relay under the MAF that sends the fuel pump voltage through a resistor to limit is power, I believe during start up and the switches to no resistance. Its possible this is your problem. You may want nto try this. http://stealth316.com/0-frames.htm I dont think its whats wrong but suggest anyway. Gonna go look at those schematics better now.
I also found a pinout for my JDM ECU. Pin 8 is labeled as "MFI Power Supply Ground". It's description is "Used to pull MFI Relay for fuel pump". So, I'm thinking of checking out to see if the ground out from the MFI is wired to that, but the question remains, which pin is the ground out on the MFI?
EDIT: On page 7 of this thread, look at the schematic that I posted there, paying attention to where pin 5 on the MFI heads to..... What do you think??
Last edited by GRSHOPR; 10-05-2010 at 11:45 PM.
Pin 5 is the ground supplied from the ECU for the fuel pump relay in the MFI. Pin 6 is the ECU supplied ground for the MFI that supplys power to the ECU and other parts.
So if it IS a failure to ground, and if pin 5 is wired correctly (which it is), then would the next thing to verify by the ground for the ECU itself?? Would it stand to reason that it can't ground the MFI if it itself is not grounded properly?
Edit: I see three chassis grounds for the ECU (pins 13, 26, and 71), one on each plug. Those are the ECU grounds, right?? And if they aren't grounded correctly, then the ECU can't ground the MFI?
Last edited by GRSHOPR; 10-05-2010 at 11:57 PM.
Well I understand you thought but the ECU is bolted to ground. And the fact that the ECU closes and then holds the MFI for a amount of time tells me it is able to supply that ground when it wants to. This tells me that for whatever reason the ECU is giving up the ground or the power is being pulled. I am leaning towards the ECU having a issue. I just dont know for sure.
|
3000gt.com 3000GT / Stealth International WWWboard Archive Jim's (RED3KGT) Reststop |
|
Team 3S 3000GT / Stealth / GTO Information daveblack.net |
|
Michigan 3S MInnesota 3S Wisconsin 3S Iowa, Nebraska, Kansas 3S |
North California 3000GT/Stealth United Society of 3S Owners 3000GT/Stealth/GTO Forums 3000GT/Stealth International |
|
3S National Gathering East Coast Gathering Upper Mid-West Gathering Blue Ridge Gathering |
Bookmarks