3D Printed Interior Custom Electronics and Gauge Trims! SAFC, ARC-2, 52mm, etc!

[3krazygt]

Bumping this for everyone.

I am just loving the new pics you posted of that radio plate.

So sexy

Ha yes I'm going to add a few to the first post. Thanks, and the center vent is printing tonight, so almost done.









Note the elegant solution for mounting the hazard switch. Yes it clicks right into place!

[3krazygt]

one more for good measure

[VANCE]

Would you have any idea of one you could make to fit a apexi safc a tein edfc control unit and a greddy electronic boost control and single din radio?

looking at the last picture I don't think there would be any way to fit all four of those in on spot.

[3krazygt]

It's not likely there would be room for all.

What gen SAFC?

If you have dimensions I can let you know what would be possible.

[VANCE]

It's not likely there would be room for all.

What gen SAFC?

If you have dimensions I can let you know what would be possible.

Most definitely not! Apexi SAFC 2. I'd probably have to mount air vent as well. always wondered how that worked though. Do you just not use air or heat or is there a bypass?

When I get back to the shop I will get dimensions of everything. I'll see if I can find some online now.

[VANCE]

ok so the edfc is 8x8x4in and the Safc is 6x6x6in haven't found the boost controller yet is smaller though. Its a Blitz Dual Solenoid Boost Controller I will continue to search while I'm at work or I will measure it tonight.

[jba3]

Any thoughts on making a few of the other small plates in the car? Might be interested in a completely blank plate to put underneath of the radio, on the center console. The spot that normally has the cig lighter, active aero, etc. Cig lighter is redundant since the car has 2, and I'd like to mount some simple switches there so a flush plate would be perfect.

I've currently got the OEM "sorta blank" plate that is the cig lighter & tiny change holder, but I'd like a simple, flat solution, with no cig lighter.

[NickS VR4]

ok so the edfc is 8x8x4in and the Safc is 6x6x6in haven't found the boost controller yet is smaller though. Its a Blitz Dual Solenoid Boost Controller I will continue to search while I'm at work or I will measure it tonight.

Those measurements right? your SAFC is a 6" cube, and your EDFC is an 8" X 8" rectangle? I think you measured one of your sides twice. Height X Width of the face is the most important part + Depth.

[VANCE]

I just went with the measurements on 3swarehouse lol

[VANCE]

I just went with the measurements on 3swarehouse lol

I was also at work but the edfc is longer than the safc for sure but idk about width and I know it isn't as tall. The boost controller is near the same height as the edfc. Ill measure them tonight