I want this plenum... anyone know who made it?

[J. Fast]

I'm looking into it more. Joined up on the galant boards. Wow, a lot of their stuff transfers!

[RealMcCoy]

When I get around to building a DS T/body intake,(someday...) I think this is the runners I'll use...

[J. Fast]

What's that off of?

[RealMcCoy]

What's that off of?

I took it off of a 2000 Eclipse 6G72. I never did look into what range of years it was produced.

[J. Fast]

Does the flange line up to our velocity stack? How long are the runners compared to ours? What size is the TB opening?

[anyonebutme]

the Sebring also had that mani

[J. Fast]

I thought the Sebring was a one piece? Isn't that the one STM is running in his drag car?

[keo92stealth]

so that plenum on the galant is only 400?? wow. looks alot better than the plenum i have. idk if its even gonna fit lol. might be interested in one of those.

[RealMcCoy]

It's sitting on a 3S lower in that picture. I never paid much attention to the throttle body, I had no intention of using it as it's on the passenger side, and angled down. I assumed a custom plenum would be built if I ever used it. (it's possible the one you made this thread about would bolt to it)

I never measured the runners, but just looking at it I would think they're slightly shorter than ours (to the bolted flange).

If you want specifics, I could go dig it out and do some measuring in the next day or so...

[RealMcCoy]

the Sebring also had that mani

I could be wrong, but I don't think it's the same one... The Sebring was a 2.5L, I think it had smaller runners, and I also thought it was a one piece.