It is time for my comeback... 2000-2500lb cornerweighed 3/S and 1000hp motor

[J. Fast]

So....Really, what hubs were modified to make your setup since they arent all billet you can tell the main hub is CAST unless thats where you spent 9K of that 10K. And is that a Tormach mill they are using to do them??

You must not be used to seeing precision work. Again, the hubs/uprights depicted are billet. They were machined in house at 3R. The same shop that builds these cars for this race team right here... K-PAX Racing - Video

[J_Parker]

So....Really, what hubs were modified to make your setup since they arent all billet you can tell the main hub is CAST unless thats where you spent 9K of that 10K. And is that a Tormach mill they are using to do them??

It's not cast, when I worked at a machinist/fabricating shop, I did very precise pieces like this as well, some of which were extremely complex head scratchers that took hours of planning. Done properly, CNC Machining should look like this... If you're seeing a lot of toolmarks, you didn't do a very good job.

Unfortunately... I never got around to making anything for my car, I wish I had. I was told I could do and use whatever I wanted, if I wanted to. Silly me

[MeTarzan]

You must not be used to seeing precision work. Again, the hubs/uprights depicted are billet. They were machined in house at 3R. The same shop that builds these cars for this race team right here... K-PAX Racing - Video

Yeah a lot of people pass off machined cast pieces as billet, looks like not much billet other than the bracket on the side.

Its a pretty bad ass looking hub but doenst look like 10K worth of work.

[zelstin]

They just look kinda similar to a Porsche upright.

[i3igpete]

speaking of things taken from a porsche...

i keed, i keed

[mehrshadvr4]

where are the updates?

[niterydr]

You must not be used to seeing precision work. Again, the hubs/uprights depicted are billet. They were machined in house at 3R. The same shop that builds these cars for this race team right here... K-PAX Racing - Video

3RTech?

[green-lantern]

where are the updates?

It’s all top secret from here on out

[green-lantern]

speaking of things taken from a porsche...

i keed, i keed

I just got it! Like 5 min later after I navigated away from this page.

[J. Fast]

3RTech?

I'm assuming you mean the person who has that screen name at 3si? Don? K-Pax and 3R Auto/ 3r Racing are not 3R-Tech. Despite what his screen name is, or what he might say, he's not a 3R Tech. It's a cool name but he doesn't work there.

I prefer to do my own work over shops like Don's (aka 3rtech). I can do it faster and just as good if not better. What I can't do on my own I pay for on a much more professional and prestigious level. I get the results I'm willing to pay for and it get's done on schedule. With guys like 3rtech you write a check and take a seat... for months, if not years, as history has proven.

... lots of guys out there you can be friends with but would never trust with finishing anything on time or entrust with money unless you're standing right infront of them watching them work...

As for the racecar, it's currently on hold till I sort out a few bugs on the street car. A few more hours of attention and it will be DD roadworthy and I can jump back into the racecar. I'm currently saving up for paint, I decided to hire it out.