What did you do today to your 3/S?

[MDoe8]

hmmm good idea. I think i have a crap 10mm i can use


Oh I also went for a test drive in my garage for motivation last night

[Uniuno]

I pushed the stealth back so I could power wash the driveway underneath it. Turned out nice :-)

[stealthee]

I got home from work to find the Stealth uncovered. Luckily one little bracket caught the cover to keep it from blowing completely away. I looked at the empty engine bay and covered it back up.

[mdcrose]

I pushed the stealth back so I could power wash the driveway underneath it. Turned out nice :-)

I'm in the same boat.

[striker2]

Swapped on the stock wheels with winter tires yesterday. Its now ready to go anywhere I need to it all winter, including the mountains for some skiing.

[MDoe8]

LS and subframe out, stock subframe back in. Old car ready to be disposed of aside from ganking (remember that word?) the mirrors. You can see all the nasty trial and error cuts i made on the car. I'm a newb at this stuff so instead of proper measuring and precision cutting, i just cut the crap out of it until it fit. Makes for a good template though to cut the new car perfectly.

[futurevr4man]

Had to rent a 3 jaw puller to get 3/4 brake rotors off. What. A. Pain. In. The. ASS. Especially on the front, cause I don't have axles, suspension, or anything to keep the knuckle upright. But finally got them.

Subframe ready to drop. New sways should be here today.

And I got a new windshield put in it on Saturday morning.

[MDoe8]

do you not have the screw slots to pop them off that way? Between that and beating the crap out of the central hub area of the rotor, i've always had success.

[stealthee]

Big FUCKIN hammer will always knock the rotors off.

[J-Groove]

Big FUCKIN hammer will always knock the rotors off.

Did the breaks on my cousin in laws truck a few months ago, had to take a damn sledgehammer to one of them.

-John