Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: Tuning for E85

  1. #1
    LW fears my posts Not Verified
    Join Date
    Sep 2010
    Owner Since
    1996, 1st Stealth TT; 2000, current TT

    Location
    Dallas TX
    Posts
    704
    Thanks
    61
    Thanked 121 Times in 102 Posts

    Tuning for E85

    Here's the deal... I'm trying to get my car registered and back on the road. Adam and I were talking about it, and one of the big hang ups is passing emissions in TX. He suggested I try tuning the car for E85, and he said a friend of his was able to pass with no cats/emissions devices on his car.

    So I did some internet searching, and found some more cases where people have passed with no cats.

    I'm not exactly sure how I'll need to tune for E85 though. Currently I have 550cc injectors. Using 35% as a guide to how much more fuel I'll need, I come up with approx. 490cc (360cc times 1.35.)

    Now, I am NOT LOOKING TO CONVERT to E85. I know I don't have enough injector/fuel pump to be able to run a decent amount of boost with my 13T's. All I want is to tune the car to be drivable on 100% E85, at a stock boost level, to drive to the inspection station and back.

    So, what should my settings be, ballpark? I have a MAFT to tune, currently it's set for 550cc. Do I turn it down slightly to 500cc and limit max boost, or do I set my MAFT to zero and turn the pressure down a bit on the 550's to equal about 500cc, and have no ECU correction?

  2. #2
    I don't bite
    Join Date
    Sep 2010
    Owner Since
    2001

    Location
    Southern IN
    Posts
    1,996
    Thanks
    59
    Thanked 98 Times in 80 Posts
    If you have 550's in; 550 x .7=385. If you set the maft to zero out, plus lower you base fp a bit, your car should run as if it has stock injectors. I would think you would want to err on the lean side just a bit, for emissions. Hopefully they don't do a visual check also, because no cat=fail in AZ, even if you pass the testing portion.
    1992 Kilder Green VR4 - First 4G swap in a 3S. 2.0, auto, awd. 9.65 at 143mph. Now LS swapped. 8.52 at 162.

  3. #3
    LW fears my posts Not Verified
    Join Date
    Sep 2010
    Owner Since
    1996, 1st Stealth TT; 2000, current TT

    Location
    Dallas TX
    Posts
    704
    Thanks
    61
    Thanked 121 Times in 102 Posts
    Quote Originally Posted by familyMAN View Post
    If you have 550's in; 550 x .7=385. If you set the maft to zero out, plus lower you base fp a bit, your car should run as if it has stock injectors. I would think you would want to err on the lean side just a bit, for emissions. Hopefully they don't do a visual check also, because no cat=fail in AZ, even if you pass the testing portion.
    That's what I was thinking, but another part of me is thinking that I still need to tell the ECU that I'm running 550's to match up with the airflow the ECU will be seeing.

    There is a visual inspection, but I've seen several inspection stations that don't actually get under the car and look for a cat. If it passes, they assume it must have one. And of course, I'm not worried that they'll see my EGR valve is gone, who would even know where to look unless they owned one? Thanks for posting.

  4. #4
    I don't bite
    Join Date
    Sep 2010
    Owner Since
    2001

    Location
    Southern IN
    Posts
    1,996
    Thanks
    59
    Thanked 98 Times in 80 Posts
    Just make sure you turn the boost down. 550's are only good for a max of 380ish awhp with E85.

  5. #5
    OG Member verified
    Join Date
    Sep 2011
    Owner Since
    2003

    Location
    Elkhart, TX
    Posts
    277
    Blog Entries
    1
    Thanks
    66
    Thanked 11 Times in 11 Posts
    Why can't you pass with regular gasoline? I've tuned cars that have passed tailpipe w/o any cats and run on 92 octane....
    Don't go to lean on idle or you will fail as well due to fuel trims and the higher hydrocarbons that may be obmitted.

    Does your state do a readiness test?

  6. #6
    LW fears my posts Not Verified
    Join Date
    Sep 2010
    Owner Since
    1996, 1st Stealth TT; 2000, current TT

    Location
    Dallas TX
    Posts
    704
    Thanks
    61
    Thanked 121 Times in 102 Posts
    Quote Originally Posted by niterydr View Post
    Why can't you pass with regular gasoline? I've tuned cars that have passed tailpipe w/o any cats and run on 92 octane....
    Don't go to lean on idle or you will fail as well due to fuel trims and the higher hydrocarbons that may be obmitted.

    Does your state do a readiness test?
    Each state sets different guidelines for emissions testing as to what is an allowable limit. I know a few guys who have tried to pass their cars running 93 octane and no cats/egr, and they've all failed over the years. Maybe your state doesn't have quite as low of a bar as we do?

    Not sure what you mean by a "readiness" test. They do a quick parking lot drive, test the brakes, horn, wipers, etc. Then if you're OBD2 they plug you in. OBD1, they sniff the tailpipe. Supposed to do a visual inspection as well, but some stations are a bit more lax than others.

  7. #7
    Is passing off a benjamin out of the question? I don't know how much time you have on your hands, but after the tuning and testing you're still just going to be crossing your fingers that you pass.

  8. #8
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2007

    Location
    Pueblo, CO
    Posts
    1,565
    Thanks
    19
    Thanked 17 Times in 17 Posts
    why not just put the cats on for the test, then take em off? No emiisions here where i live

    1/4 mile 11.80 @117mph. 551whp 641trq @ 26psi E85 tune, MTC 19T-HLs, forge 15psi spring wastegates, 780 PTE inj, 3SX Fuel loop, ss fuel lines, Engine built by Laniers Speed shop, block bored .060 w/ chromolly rings, weisco pistons, 3sx custom forged rods, forged crank, HKS DLI, AEM EMS, AEM UEGO wideband, prosport oil and boost guages, aeromotive 1000 FPR, Dejon blow thru twintakes, Walbro E85 400 w/ 3sx hotwire kit and custom an fitting fuel pump w/ STM filter to pump line, CXRacing FMIC, Megan Racing Aluminum radiator, IPS custom downpipe, Borla 3" exhaust,Greddy profec b spec II EBC, Blitz SS BOV,R1 Drilled slotted rotors, Drag DR-31 rims, RPS stage 4 unsprung clutch,

  9. #9
    SoSoCal verified
    Join Date
    Sep 2010
    Owner Since
    2002

    Posts
    692
    Thanks
    23
    Thanked 25 Times in 21 Posts
    Quote Originally Posted by UTRacerX9 View Post
    Each state sets different guidelines for emissions testing as to what is an allowable limit. I know a few guys who have tried to pass their cars running 93 octane and no cats/egr, and they've all failed over the years. Maybe your state doesn't have quite as low of a bar as we do?

    Not sure what you mean by a "readiness" test. They do a quick parking lot drive, test the brakes, horn, wipers, etc. Then if you're OBD2 they plug you in. OBD1, they sniff the tailpipe. Supposed to do a visual inspection as well, but some stations are a bit more lax than others.
    The readiness test is an OBDII thing, they plug in the pc and it checks if all is working, if it is, your are done! No sniffing tailpipe.

  10. #10
    LW fears my posts Not Verified
    Join Date
    Sep 2010
    Owner Since
    1996, 1st Stealth TT; 2000, current TT

    Location
    Dallas TX
    Posts
    704
    Thanks
    61
    Thanked 121 Times in 102 Posts
    Well... after a 4-5 month hassle... I got my inspection done.

    Didn't end up having to tune for E85, though since there is a station not too far from me I still may end up going that route, if a hotwired Supra pump can supply enough fuel to run 17psi or so with 13T's. I would just need bigger injectors I think. Based on Jeff's site and his injector page, I think I could get away with a single Supra pump, but would it be worth it for just running 17psi? (Which is what I run now, 16-17psi on 93.)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The 3000GT/Stealth/GTO Web History Project
3000gt.com
3000GT / Stealth International WWWboard Archive
Jim's (RED3KGT) Reststop
3000GT/Stealth/GTO Information and Resources
Team 3S
3000GT / Stealth / GTO Information
daveblack.net
3000GT/Stealth/GTO Clubs and Groups
Michigan 3S
MInnesota 3S
Wisconsin 3S
Iowa, Nebraska, Kansas 3S
North California 3000GT/Stealth
United Society of 3S Owners
3000GT/Stealth/GTO Forums
3000GT/Stealth International
3000GT/Stealth/GTO Event Pages
3S National Gathering
East Coast Gathering
Upper Mid-West Gathering
Blue Ridge Gathering