What did you do today to your 3/S?

[94stealthr/t]

Cleaned my break calipers so I can rebuild them tomorrow and paint them red

[Silver]

New windshield is in. Amazing how much clearer everything is now, lol
Think I'm happier about having a clean, clear windshield more than not having a crack halfway across :P

Looking pretty good Silver. What did you use for terminals? I used bolts and that worked out great.
Also, looks like we're going opposite routes, lol. You're removing fabric, I'm adding it.

My old MTX box had terminals on the back that i used. It comes with a plastic insert that the posts mount to and a gasket to seal it to the box. This is what they look like.



My box had 2 of these (one for each speaker) and they are 4 ohm not 2 ohm. I just used a circle cut bit and cut the exact size for the part of the insert that enters the box, drilled the 4 holes for the screws and bam was done, plus it adds a nice factory look to the box.

[2fnloud]

Bolts work great as terminals:

inside:

outside:

what it is:


Center channel for my up coming Dolby DTS 5.1 mobile theater.

[Snook]

Bolts work great as terminals:

inside:

outside:

what it is:


Center channel for my up coming Dolby DTS 5.1 mobile theater.

Stop making me jealous Steve.
Anyway replaced coils, plugs and MAF.

[j2k4]

Drilled the holes along the back of the box for the posts and installed them. The went ahead and drilled the holes for the subs themselves and installed them as well. Decided to fire it all up and see how it sounded. I was worried the subs would just sound like poo with a smaller box but to my amazement they sound awesome. Oh and dont mind my ghetto wiring job.. it was getting late and i just wanted to test it out. everything will be relocated and hidden.

Wish you'd been doing this back when I was putting my system together - I'd looked at that sort of configuration, but I'd frankly lost my taste for solving that sort of fitment.

Nice work, Silver

not a damn thing.

+1

[anyonebutme]

Drove it around STL.

Still gonna need an engine, lol. It also has the worst clutch ever.

[Street_Chally73]

I worked some more on the upper intake plenum...My thumbs & index fingers are RAW!!!
(BTW: these were older photos from the afternoon)
I can't wait to be done with the sanding part of it!! Only about another 10 hours or so & it should be ready for some buffing.-

Oh, & I also got my HPS silicone radiator hose kit & other heater hoses in today (well, technically yesterday).


Sent from the garage

[Blackmount]

Installed ebay downpipe.. car sounds awesome. Definitely added some balls remove 2/3 of the cats. Right around 3500rpms at wot the turbos initiate lift off and the car just takes off like a bat out of hell

[Ange]

trying to figure a way to fixate the lcdbc knob in the cig lighter trim..

[TT4ME]

New Battery
Bath
Clean inside of windows
Removal of most of the "tree sap"
Start buffing & polishing paint - half of the hood looks ok

May have to find a shop to finish the buffing...

Before


After