Page 1 of 2 12 LastLast
Results 1 to 10 of 15

Thread: Running like crap.

  1. #1
    Forum User
    Join Date
    Sep 2010
    Owner Since

    Location
    Northeast NE
    Posts
    8
    Thanks
    2
    Thanked 0 Times in 0 Posts

    Running like crap.

    My 1992 RT/TT has been running poorly off and on since I've known it. My brother and I have scanned it, and it doesn't fire on cylinder 6 and the engine light comes on almost every time it runs lately. This problem usually only occurs when the engine reaches operating temperature. It used to kind of clear up after running at highway speed for a while, and coolant temp has never been out of the ordinary. The code says injector circuit and also tps.
    We know it isn't the ecu, because it runs my brother's 93 just fine. Could it be the tps? we can't switch tps s because 92 and 93 are different.
    This is really bothering me, and I really need my car. I can't figure out why it would miss and why the tps would only be bad after running for a while. Anyone have any ideas or suggestions?
    Any ideas would be very appreciated. Thanks a lot in advance.
    Last edited by luke_hkd; 11-07-2011 at 11:57 PM.

  2. #2
    Forum User
    Join Date
    Sep 2010
    Owner Since
    2008

    Location
    Lincoln
    Posts
    71
    Thanks
    5
    Thanked 3 Times in 2 Posts
    Have any wise people ever had this issue? I've dug up several threads with these same symptoms but the threads always die before the resolution

  3. #3
    JNS Engineering verified
    Join Date
    Sep 2010
    Owner Since
    1994

    Location
    San Jose, CA
    Posts
    2,112
    Thanks
    61
    Thanked 155 Times in 110 Posts
    If #6 isn't firing have you determined whether it's a spark or fuel issue? There's a similar unresolved thread on the other site that appears to be a fuel issue on #4.

  4. #4
    Padawan garage troll Not Verified
    Join Date
    Sep 2010
    Owner Since
    2004

    Location
    Newark, DE
    Posts
    635
    Blog Entries
    5
    Thanks
    68
    Thanked 23 Times in 21 Posts
    There are numerous things that can cause the 'running like crap.' But since you are getting codes...I would focus on that, as Jim mentions. Pull spark plug #6 and assess condition. I believe the code only tells you which bank, so you will need to check the rear bank IIRC, may as well check all while you are there anyway.

    Plug condition will lead you to answers...is it soaked with fuel, no spark, could be anything in the 'fire' spark, plug, wire, coils, etc. How does the suspect plug look compared to others? If its less brown looking, could have a fuel issue in that cylinder...ie injectors, filter, fuel pump, regulator etc.

    Stealth 316 - Spark Plug Change
    Last edited by Roybatty; 11-11-2011 at 05:12 PM.
    91 AWD TT
    K&N FIPK, Precats gutted, Test Pipe, Blitz DSBC, Walbro 255, Vacuum reduction, SM3, MMCd, Krank Vents, 3SX Aluminum Crank Pulley, Aluminum 2PC DS, MAFT Pro (AFC mode atm).

    To do list: Need to check electronic timing, install FP hotwire, install PS poly MM, RUACAs, Setrab oil cooler, Dejon Y-pipe, 3.5 GM Mas, FIC 650ccs & 13Ts.

  5. #5
    Forum User Not Verified

    Join Date
    Sep 2010
    Owner Since
    2004

    Location
    Cape Girardeau
    Posts
    4,791
    Thanks
    365
    Thanked 296 Times in 214 Posts
    I would replace the rear injector harness. It replaces all 3 rear injector wires and clips. About $25.00 from cherry hill mitsu.

    Sent from my DROIDX using Tapatalk

    Parting 6 speed
    Pampena 3.5 Stroker, GTX 2867 Gen IIs, AEM Series2, oohnoo SMIC, DN Hardpipes, FIC 1650s, Walbro 525, aermotive fpr, Dejon intake pipes, Tial Q, Koyo Rad, Samco Hoses, Stoptech 332mm fronts, HKS GT4 Coilovers, Spec 4+ LW, JDM 6 Speed, Billet shift forks, Pampena brace

  6. #6
    JNS Engineering verified
    Join Date
    Sep 2010
    Owner Since
    1994

    Location
    San Jose, CA
    Posts
    2,112
    Thanks
    61
    Thanked 155 Times in 110 Posts
    Quote Originally Posted by Forest Gump View Post
    I would replace the rear injector harness. It replaces all 3 rear injector wires and clips. About $25.00 from cherry hill mitsu.

    Sent from my DROIDX using Tapatalk
    Not a bad suggestion but be sure to get the correct one as the NA and turbo cars use a different harness.

  7. #7
    Forum User
    Join Date
    Sep 2010
    Owner Since
    2008

    Location
    Lincoln
    Posts
    71
    Thanks
    5
    Thanked 3 Times in 2 Posts
    results: we just replaced the TPS and calibrated it with the datalogger. The car ran better than it had since june when it got really bad (couldn't drive 3 miles without the CEL coming on). Everything logged great and no issues. Turned it off and started it back up about 20 minutes later and it threw its codes 14 and 41 again, and its missing on cylinder 6(again). What is going on? I'm completely at a loss at this point and i don't know what to try next. It has something to do with the temperature of the engine compartment i know that for a FACT. Please help, thanks
    Jake

  8. #8
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since

    Location
    Easton
    Posts
    340
    Thanks
    15
    Thanked 8 Times in 8 Posts
    Did you change the rear injector harness? Code 41 is the injector circuit.

  9. #9
    Honda Eater
    Join Date
    Sep 2010
    Owner Since
    April 2007

    Location
    Ontario, Canada
    Posts
    334
    Blog Entries
    1
    Thanks
    4
    Thanked 6 Times in 1 Post
    maybe check the wiring to your injector harness?.. maybe #6 isn't plugged in properly?.. could also be a wiring issue.

    pull #6 sparkplug, smell if fuel is getting to it, also check to see if the sparkplug is giving out spark.

  10. #10
    Forum User
    Join Date
    Sep 2010
    Owner Since

    Location
    Northeast NE
    Posts
    8
    Thanks
    2
    Thanked 0 Times in 0 Posts
    Spark plugs are great, so scratch that variable. Going out to inspect harness and replace injector 6 now. Have some spare injectors laying around so it's worth a try right?

    Could engine heat cause injector failure like this? Before the car warms up, it runs great and doesn't miss. This conditional failure is what puzzles me. We thought we had it fixed during the test drive after the TPS replacement because it ran so strong. It even got pretty warm and the CEL didn't turn on and it didn't miss. Only upon restarting the engine after a few minutes did it start missing again. Then a few hours later we drove it again and it only ran good for about a mile before the CEL and missing returned.

    So for now, I'm going to try injector. Then the injector harness I suppose. Others have had similar issues caused by ECU and TPS, both of which are known to be good in this instance.

    Edit: Found out plug wires are serviceable but should be replaced soon. After changing the injector, nothing has changed. The harness looks just fine as well.
    Last edited by luke_hkd; 11-28-2011 at 04:23 PM.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The 3000GT/Stealth/GTO Web History Project
3000gt.com
3000GT / Stealth International WWWboard Archive
Jim's (RED3KGT) Reststop
3000GT/Stealth/GTO Information and Resources
Team 3S
3000GT / Stealth / GTO Information
daveblack.net
3000GT/Stealth/GTO Clubs and Groups
Michigan 3S
MInnesota 3S
Wisconsin 3S
Iowa, Nebraska, Kansas 3S
North California 3000GT/Stealth
United Society of 3S Owners
3000GT/Stealth/GTO Forums
3000GT/Stealth International
3000GT/Stealth/GTO Event Pages
3S National Gathering
East Coast Gathering
Upper Mid-West Gathering
Blue Ridge Gathering