PDA

View Full Version : WANTED INTRAX SPRINGS for NON ECS 1997 VR-4


vr4tune
03-25-2012, 03:58 AM
Looking for a set of intrax springs for my 1997 VR-4.



Intrax Part # 55.1.013
Rear spring # 47-020 (printed on rear spring)
vr4tune
04-01-2012, 08:46 PM
Bump! Any leads would be appreciated.
R/T93
04-01-2012, 08:51 PM
Good luck!
saiba31123
05-10-2012, 06:53 PM
Good luck!

why do you want intrax?
vr4tune
05-11-2012, 06:07 AM
Because they make a spring that fits the rear of a non ECS vr4 (96-97).
mb7050
05-11-2012, 06:32 AM
you could just swap the rear upper strut mount to an "ecs" one and run any lowering springs.
vr4tune
05-12-2012, 07:06 PM
This is true! But the insulation top mount is not cheap from Mitsubishi. Plus it still won't fit the lower mount on the strut perfectly.
guido1205us
05-12-2012, 10:51 PM
Couldn't you swap in some ecs struts, mix and match parts from you stockers with any other lowering springs? At least that was my thought as I was going to pick up some rear ecs cheap from ebay.

I never did like the over sized eibach springs on stock non ecs rear perch - didn't know intrax made rears that fit. Thanks for the info.
vr4tune
05-13-2012, 05:38 AM
Couldn't you swap in some ecs struts, mix and match parts from you stockers with any other lowering springs? At least that was my thought as I was going to pick up some rear ecs cheap from ebay.

I never did like the over sized eibach springs on stock non ecs rear perch - didn't know intrax made rears that fit. Thanks for the info.

I don't like the idea of ECS shocks in the rear that I can't control.