PDA

View Full Version : subframes



gaylantvr4
11-20-2011, 10:32 PM
i want a front subframe to powdercoat and was woundering if the na subframe is the same as the tt?

green-lantern
11-20-2011, 10:53 PM
The rear subframe? Not even close.

TUFFTR
11-21-2011, 07:42 AM
Front one is the same IIRC.

DrGonzo
11-21-2011, 11:03 AM
Front is the same!

gaylantvr4
11-21-2011, 08:59 PM
Thank you, What about the lower controle arms?

IPD
11-21-2011, 09:05 PM
iirc, virtually everything is the same (or is interchangeable) on the front for n/a vs. tt....except for axles.

Hans@GZP
11-23-2011, 12:21 PM
As long as the front control arms aren't from a SOHC, you will be fine. Must be DOHC arms

Gearheadvr4
11-23-2011, 03:33 PM
Axels are different because of the trans or the rotors being larger?

DrGonzo
11-23-2011, 04:56 PM
Curious as to why they are different also??

The trans, axles and hubs are the same?!?!?

speedy25
11-23-2011, 08:40 PM
I got used replacements for a car and found that a few of the holes on the right side didnt line up properly. I think there is a difference between auto and manual trans.

-SP

IPD
11-24-2011, 07:47 AM
Axels are different because of the trans or the rotors being larger?

axles are different because of trans. for example, my fwd > awd conversion required different axles--even though the transmission remained atx.

IPD
11-24-2011, 07:48 AM
Curious as to why they are different also??

The trans, axles and hubs are the same?!?!?

no, but they are interchangeable. (axles must match hub).

gaylantvr4
11-24-2011, 11:46 AM
ok there is a 95 dohc fwd m/t in a pick n pull yard i am going to get. I just need the sub frame and controle are to powder coat

stealthee
11-24-2011, 12:03 PM
The axles are actually pretty much the same down to the splines. The major factor is length. I could put the VR4 knucles on my car and my FWD axles will fit with no modification. Hell I could even pop my axles into an AWD trans. The only FWD axles that can't do that is 91-92's because they have a smaller diff.