View Full Version : water temps
I have an aftermarket coolant temp gauge. its located where stock gauge was in (sensor). when starting the engine when its cold, gauge slowly goes up. so while logger shows 180F, gauge is only at 120F or so, after a while it reaches 160-180F eventually. is this normal? where does ecu/logger get its signal?
x2xtreme360
10-27-2011, 06:19 PM
The PCM gets its signal from the temp sensor right next to the gauge sensor. 120 on the gauge while the logger is at 180 is pretty bad. I suppose if it's fine when it heats up then I wouldn't worry too much about it.
Valhallaz
10-27-2011, 09:59 PM
Did you use some sort of adaptor to mount the gauge sensor? Maybe the sensor is too shrouded?
DrGonzo
10-27-2011, 11:33 PM
What logger are you using??
I have the same issue. My aftermarket gauge will say 180-190 but MMCD will say 210-220. All my sensors are brand new so I am thinking it is either how the ECU it determining the signal or that MMCD is not converting it correctly.
I am trusting the gauge as the fans kick on at 195 which is where it is supposed to, So my guess is that MMCD is not reporting the temps correct
rawavr4
10-28-2011, 12:08 AM
My coolant temp gauge is about 10 degrees off until the car is fully warm, then it reads right on with the scanmaster. I think the reason is because the adapter to screw the probe into the stock hole pretty much covers the whole temp probe. The ecu temp probe is right in the coolant stream while the gauge probe is doesnt even reach the housing through the adapter.
GTOJOE
10-28-2011, 04:05 AM
do the gauge and the logger both show the same temp when cold? when setting up my Vi-PEC EMS I had to find the correct sensor type. I was able to do this by matching the intake air temp and coolant temp temperatures whe nthe car was completely cold. I know 100% what type the IAT sensor was so I then just changed the coolant sensor type till the both matched.
Does the MMC program have an option to choose a brand/type of sensor? If no then one of them could be faulty if they don't match.
I'm not using any adapters. when warmed up, both show 180F, never went over 185F yet. but I did not take the car to the track either. using dsmlogger and mmc.
I started to think that maybe it because gauge shows temps after the thermostat? like already cooled water. but does not look that way to me, under the hood.
Chris@Rvengeperformance
10-28-2011, 08:49 PM
Greddy sensor screwed into stock location on mine and it moves in lockstep with logger from dead cold.
Sent from my DROIDX using Tapatalk
Alex3000gt
10-28-2011, 08:54 PM
Is one sensor reading top tank and the other sensor reading bottom tank?
Hysteresis?
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.