PDA

View Full Version : Problems with Hallman Pro MBC



B-Man
07-14-2011, 10:35 PM
Purchased a Hallman Pro MBC from STM during their Xmas sale last year. Installed it in March when the weather was warming up. It ran great for awhile but slowly I kept getting less and less boost at the same setting.

Ok, I figure springs are breaking in. I kept turning it (in the direction labeled on the controller for more boost) and I don't get any more boost. NG comes around and turns out I'm only running 12psi. By the time I leave NG I'm running 10psi and have been giving it a half a turn (maybe a little more) when I leave for work and on my way back. So that's 2.5 turns a week and no change.

Tonight, I just unplugged my pressure source to my wastegate and ran it while closely monitoring my boost. Easily makes it to 16psi.

Is there a stop when it's all the way in? Is my hallman bad already? Is there any warranty on these?

IPD
07-14-2011, 11:29 PM
sure you don't have a boost leak?

B-Man
07-14-2011, 11:42 PM
I haven't check it in awhile, but that wouldn't make any sense to me since it'll make all the boost you want with it disconnected.

sublime_whatigo
07-15-2011, 02:18 PM
Pull it apart, assuming its still a ball and spring. Stretch it a touch and clean it out good.

B-Man
07-15-2011, 03:34 PM
Top just threads off like you'd expect?

i3igpete
07-15-2011, 03:57 PM
not the knob side, but the nipple side. don't tighten it too much when you put it back together or you'll rip the O-ring, hallman actually recommends using your hands to tighten instead of a wrench.

B-Man
07-15-2011, 04:31 PM
They say on their website to just send it in if there's any problems, so I may just contact them and do it while the car is down....again :mad:

i3igpete
07-15-2011, 04:39 PM
There's really not much else that can go wrong and cause your issues, other than the spring getting grime on it and staying partially compressed, or the o-ring on the inlet side getting ripped.

anyonebutme
07-17-2011, 02:35 PM
Or the ball sticking to the seat, causing a massive spike to 24+psi on pump gas and nearly costing me an engine...

CoopKill
07-17-2011, 06:40 PM
That happened to me when a vac line came off my HKS EVC! Scared the crap out of me...

B-Man
07-17-2011, 07:14 PM
That happened to me when a vac line came off my HKS EVC! Scared the crap out of me...

Zip Ties + Barbs are your friend.

CoopKill
07-17-2011, 10:01 PM
Yes, I had barbed connectors. Two plastic ones broke... I went to brass, lol.

B-Man
07-18-2011, 07:27 PM
So, I took it apart and everything looked fine. No corrosion, no broken seals, nothing. The seat looked a little rough, but not bad enough it shouldn't be holding boost. Reassembled. 15+psi first pull. Not sure what happened.