View Full Version : Oil sender issue
Rocket
06-21-2011, 01:37 AM
Anyone run into this problem? I installed new oil pressure gauge and the sender needed an adapter to fit the metric hole. Seemed ok and seems to work well. Got the axles back in tonight and found this issue.
2839
The sender is touching the cv boot :( can i switch it with the switch? If not it is use a angle adapter? Any ideas?
Tia
Sent from my Droid using Tapatalk
Hans@GZP
06-21-2011, 07:35 AM
Those big sender units require a 90 degree adapter.
Rocket
06-21-2011, 01:28 PM
That was my initial thought Hans, thank you for the confirmation :)
n2nsanity
06-21-2011, 02:27 PM
i dont think it matters which hole u use, however one might be more accurate than the other
i currently have my oil switch and a mechanical guage on a T from the oil pump
that's how the instructions from the guage kit recommended anyway
i hate messing with these things. such a cramped spot to work and you have to drain the oil every time you mess with them
hans, why is the 90* angle needed? is too high or too low pressure if it were straight?
or is it just so it won't touch the axle?
Emilie@GZP
06-21-2011, 02:36 PM
just so it won't hit the axle
DrGonzo
06-21-2011, 03:42 PM
I never used an adapter. I just threaded the sender into the hole. NPT is close enough to BSPT...LOL
Hey it doesn't leak and it works :P
Rocket
06-21-2011, 04:39 PM
I did that with the temp sender. The oil sender didn't want to start in the hole so I went with the adapter :)
Rocket
06-22-2011, 10:26 PM
A 45 degree adapter fixed the problem. The sender now points parallel with the ground under the power steering pump. All is good :) n2nsanity I didn't drain any oil dealing with it. It drizzled about a teaspoon of oil out and then it was done. Looks good and works too :)
n2nsanity
06-23-2011, 12:03 AM
i drain it because i spray a ton of brake cleaner and stuff and hit it with a wire brush
maybe im just paranoid about getting any dirt in the oil
Rocket
06-23-2011, 12:10 AM
Ahh ok that makes sense.. had me worried that when I pulled it I would have a huge leak :) Everything down there was clean so I wasn't as worried about that :P
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.