PDA

View Full Version : should any of my safc setting be in the positive?



Kilo_SME
03-02-2011, 03:58 PM
Stock tt injectors and NA ecu. Is that running running to rich? I don't have a wideband and the logger I have is useless. Any help would be great thanks.

dpartinvr4
03-02-2011, 04:28 PM
how much boost are you running?

Kilo_SME
03-02-2011, 04:36 PM
Wastegate boost.(7psi) and its a atx

dpartinvr4
03-02-2011, 05:38 PM
then you don't really need an safc....but no, everything should be set at zero.

Kilo_SME
03-02-2011, 06:18 PM
Are you sure? With a NA ecu?

Alan92RTTT
03-02-2011, 06:37 PM
Yes, you need the afc with the NA ecu.

What fuel pump?

I think they should all be negative but wait till someone with more experience posts to be sure.

dpartinvr4
03-02-2011, 06:58 PM
Are you sure? With a NA ecu?
My bad, I didnt realize you have an na ecu....in the positive might be ok then, it depends on some other things..i.e. Fuel pump, injectors, and.a dataloger would really help....do you know if the na and tt engines fpr's are set to the same pressure? And wich do you have?

Greg E
03-02-2011, 11:12 PM
Not sure how you're going to tune your car without knowing what the narrowbands are communicating with the ECU but it's not uncommon to richen up the lower rpm values then gradually lean them out.

Lithium
03-03-2011, 01:22 AM
you need a wideband and a logger, bare minimum.

Kilo_SME
03-03-2011, 04:25 AM
I have a logger but it doesn't show any knock sensor, and I think the a/f is in volts or something. The car ran pretty good with the the high settings in the positive. I rather run too rich then too lean, but the way gas is going up I can't afford that.lol. Also im still on the NA fuel pump and fpr.

dpartinvr4
03-03-2011, 08:35 AM
. Also im still on the NA fuel pump and fpr.
fail........

Kilo_SME
03-03-2011, 09:57 AM
fail........

Why is that? Big tayga ran his tt atx with the NA fuel pump with no problems. And as I said before the cars runs very strong. Just don't want to be running to rich or lean and get lil better tune.

FeaRpb
03-03-2011, 10:02 AM
Widebands - AEM UEGO Wideband O2 Air/ Fuel Gauge - Maximal Performance (http://www.maximalperformance.com/store/widebands/aem-uego-wideband-o2-air/-fuel-gauge/prod_10.html)

Best $180 you can spend.

dpartinvr4
03-03-2011, 10:14 AM
I just wouldn't run the car with minimal fuel upgrades and no datalogger to check IDC's and AF/R......because you really can't try and use the SAFC if you don't know what your tuning it to. and you can only use other peoples setups to an extent, as every car will run and react different to tuning.

Lithium
03-03-2011, 12:15 PM
you would have to up your fuel pressure to keep the IDC down with a NA injectors and pump. Im not sure of how high but I wouldnt want to go any higher then 60 PSI with our stock fuel components. If your interested I have a set of 360cc I just took out of my car. I would let them go for cheap to help you out.

dpartinvr4
03-03-2011, 01:10 PM
you would have to up your fuel pressure to keep the IDC down with a NA injectors and pump. Im not sure of how high but I wouldnt want to go any higher then 60 PSI with our stock fuel components. If your interested I have a set of 360cc I just took out of my car. I would let them go for cheap to help you out.

He's got tt injectods... I just don't know what the na pump flows and what the na fpr is set at....but deff invest in a dataloger and wideband

Atrosity
03-03-2011, 01:12 PM
You need this before you boost again.

Check List-

-Wideband
-Upgraded Fuel Pump w/hotwire kit
-Datalogger

Lithium
03-03-2011, 01:40 PM
He's got tt injectods... I just don't know what the na pump flows and what the na fpr is set at....but deff invest in a dataloger and wideband

I must have missed that. I believe the N/A pump can hold a good amount of pressure. If you really dont want to upgrade the pump I would at least hot wire the N/A pump and bypass the stock FPR solenoid. Doing so will put your fuel pressure around 50PSI.