PDA

View Full Version : Beyond clueless



3kgt1734
12-06-2010, 08:09 PM
A couple of weeks ago my car was running just fine, until I pulled into my driveway at which point it just died. I tried to start it back up and it did nothing but crank. I finally figured out I had no spark. I replaced the coilpack. Same thing, no spark. Then I replaced the CAS. The car started up and shortlly after died! And now it will just sit there and crank but not start! SO now I have spark, but no fuel. I have fuel to the rails so I assume that my injectors aren't firing?

Here's a video of me testing the spark. That should good enough spark to star the car? correct?
Also, in the video, what is that noise right before I crank it and right after. It happens when I turn the key to accessory

http://tinypic.com/player.php?v=2nqwpxd&s=7

x2percentmilk
12-06-2010, 08:49 PM
Just to start eliminating things, did you check all fuses under the hood? Can you verify that the pump is working?

3kgt1734
12-06-2010, 09:47 PM
I did check all the fuses under the hood. They are all good.

I tested the fuel pump two weeks ago, and figured out I had fuel to the rails.

I'll check again later though.

J_Parker
12-06-2010, 09:56 PM
Check your resistor pack, resistors in the ECU, and all corresponding wiring, also check to see if you've power to the injectors.

3kgt1734
12-06-2010, 10:22 PM
Check your resistor pack, resistors in the ECU, and all corresponding wiring, also check to see if you've power to the injectors.

Hold up. Do NAs have a resistor pack?

x2percentmilk
12-06-2010, 10:41 PM
No just the TT's

Steve '92ES
12-06-2010, 11:21 PM
try unplugging the ISC and see if it still makes that noise.

Roybatty
12-06-2010, 11:28 PM
Just to start eliminating things, did you check all fuses under the hood? Can you verify that the pump is working?
:smartie:

Been down the replace things road. The basics are fuel, air and spark. You have spark, you need to verify the rest. The manual has tests for all these; but a quick run down is pump, filter, injectors. Check the simple stuff first.

http://www.3sx.com/faq/manuals/

J_Parker
12-06-2010, 11:53 PM
Hold up. Do NAs have a resistor pack?

Oh, didn't realise yours was N/A :p

3kgt1734
12-07-2010, 12:20 AM
:smartie:

Been down the replace things road. The basics are fuel, air and spark. You have spark, you need to verify the rest. The manual has tests for all these; but a quick run down is pump, filter, injectors. Check the simple stuff first.

http://www.3sx.com/faq/manuals/

Thanks!


Oh, didn't realise yours was N/A :p

HATER :)

3kgt1734
12-07-2010, 12:34 AM
... Okay so that manual just kicked my ass all over the place.

That is WAYY to much for my uneducated brain to handle!

Seriously though, not to long ago while I was trying to start the car I heard the MFI click a couple of times. Could that be causing me to get no fuel?

Tomorrow when I get back from school I'll see if I have fuel to the rails again. If I don't I guess that either I have a bad MFI or fuel pump correct? and if I do have fuel to the rails then what? Test each injector like the manual says?

ahh the joys of owning a 3s!

J_Parker
12-07-2010, 01:14 AM
HATER :)

No, no, no, I love all 3/S' ... If you wanna see a hater, you'd enjoy me "talking" with a Civic enthusiast :D

Mikes2nd
12-07-2010, 09:05 PM
1. have you verified your ECU is perfect?

3kgt1734
12-07-2010, 11:18 PM
1. have you verified your ECU is perfect?

nope, I don't have another one to swap into it.

Mikes2nd
12-08-2010, 05:29 PM
Send it out for a checkup. I am very confident if you don't know your ecu state, its in need of a repair.

3kgt1734
12-08-2010, 08:03 PM
Send it out for a checkup. I am very confident if you don't know your ecu state, its in need of a repair.

???

I pulled the ECU and checked for leaking caps and for "fishy" smells. There is nothing visibly wrong with it. Is the ECU a common thing to go out?

dbest671
12-08-2010, 08:16 PM
???

I pulled the ECU and checked for leaking caps and for "fishy" smells. There is nothing visibly wrong with it. Is the ECU a common thing to go out?

What year is your car? The 1st Gens are notorious for having problems, the 2nd Gens not some much.

3kgt1734
12-08-2010, 08:20 PM
What year is your car? The 1st Gens are notorious for having problems, the 2nd Gens not some much.


It's a 95 base

dbest671
12-08-2010, 08:26 PM
Then the ECU is probably NOT the problem, but it still could be a slim possibility.

mcshooter
12-09-2010, 12:19 AM
here in ohio where the temps change from warm to cold just about all ecus are defective after 10 years. a friend of mine is a mitsu mech and this is from his experience

Mikes2nd
12-09-2010, 04:22 PM
second gens are okay though...

dbest671
12-09-2010, 06:41 PM
Second gen ECU go bad. I was just saying that the chance of his ECU being the culprit is a very slim possibility, but it is still possible.

3kgt1734
12-09-2010, 06:53 PM
Alright. Well assuming it isn't the ECU. What would your next guess be for no fuel? MFI? or the actual pump its self?

GTOJOE
12-09-2010, 07:49 PM
Pull the fuel line off the FPR [fuel return] and see if your getting fuel flow. You have fuel in the rails but that doesn't tell you if the pump is working correctly. You need to run it and see how much fuel comes out after 30 seconds. There is a formula to work out how much fuel should be flowing but I can't remember it (sorry). Also you can usually feel a slight tick from the injector if it is running so maybe get someoen to crank it over and hold your finger on the injector and see if you can feel any difference.

Steve '92ES
12-09-2010, 09:01 PM
try unplugging the ISC and see if it still makes that noise.

Let me elaborate a bit. Bad ISC motors have been known to take out the injector drivers. If that noise you're hearing is the ISC than unplug it and ohm test it before it does any (more?) damage. It's quick, it's easy, it's worth trying.
From http://www.stealth316.com/2-isc-iac.htm


2. ISC servo. Press down on the release lever of the wiring harness connector and pull it off the ISC servo. You may have to wiggle it a little as you pull. Do not pull on the wires. At this point you can test the resistance of the four coils or wait until you have the ISC servo off the throttle body. To perform this test, measure the resistance between terminals 2 and 1, between 2 and 3, between 5 and 4, and between 5 and 6. The resistance should be in the range of 28 to 33 ohms for the original and older models, and ~40 ohms for the most recent model, which is after our 3S cars were manufactured (see http://www.dsmisc.com/). The results for me were 30.1, 30.1, 30.3, and 30.4 (same order as given above) with the ISC servo off the throttle body.

stealthee
12-09-2010, 09:25 PM
here in ohio where the temps change from warm to cold just about all ecus are defective after 10 years. a friend of mine is a mitsu mech and this is from his experience

I live in PA and have ven more extreme temps from hot to cold. ECU's don't go bad because of temp fluctuations. My car has around 200,000 miles on it with the original 17 year old ECU and its fine. Thats probably one of the stupidest things I have ever read.

3kgt1734
12-09-2010, 10:55 PM
Let me elaborate a bit. Bad ISC motors have been known to take out the injector drivers. If that noise you're hearing is the ISC than unplug it and ohm test it before it does any (more?) damage. It's quick, it's easy, it's worth trying.
From http://www.stealth316.com/2-isc-iac.htm

Thanks. I'll test that tomorrow.

"does any (more?) damage." lol. So if this turns out to be my problem what else has been messed up by it.

stealthee
12-09-2010, 11:00 PM
I may have missed it but are you sure it didn't jump time?

3kgt1734
12-09-2010, 11:27 PM
I may have missed it but are you sure it didn't jump time?

I pretty sure it didn't jump time. The cam marks on the front head lined up.

...now you got me worried

Steve '92ES
12-09-2010, 11:38 PM
So if this turns out to be my problem what else has been messed up by it.
Well, like I said, it can take out the injector drivers in the ECU so what gets messed up? The ECU.
Don't get me wrong, I'm not saying that the problem, just that the potential for damage is great and the test is easy.
If it were my car not starting and the ISC chattering I'd have it unplugged so fast you wouldn't see it happen...


I may have missed it but are you sure it didn't jump time?
I was wondering that myself..


Thats probably one of the stupidest things I have ever read.
I wouldn't say stupid so much as overstated. Temperature does stress electronics, but it's mostly heat that does them in. Here in the northeast where you go from maybe high 80s/low 90s to 20/30 degrees is only a 60-70 degree swing which ain't all that extreme...

3kgt1734
12-09-2010, 11:51 PM
Well, like I said, it can take out the injector drivers in the ECU so what gets messed up? The ECU.
Don't get me wrong, I'm not saying that the problem, just that the potential for damage is great and the test is easy.
If it were my car not starting and the ISC chattering I'd have it unplugged so fast you wouldn't see it happen...


AH! Things are starting to make sense! Alright so unplug it and if the noise stops it could be my IAC?

I just had a mild seizure, the part is 305 bucks. I'm walking for the next three weeks it looks like! lol.

Steve '92ES
12-10-2010, 12:04 AM
They're under $80 at Rock Auto... but lets not get ahead of ourselves.

Mikes2nd
12-10-2010, 11:18 AM
I live in PA and have ven more extreme temps from hot to cold. ECU's don't go bad because of temp fluctuations. My car has around 200,000 miles on it with the original 17 year old ECU and its fine. Thats probably one of the stupidest things I have ever read.

congrats you got lucky, but you obviously have no clue about capacitors... seriously I know your favorite reply is "OMG YOUR STUPID" but your being the dumbass. Read about "capacitors" and how they contain "electrolyte"...

PA does not have "extreme heat"... the majority of your year is fairly cool... I live right next door so I know. Cold is good for caps, high heat is not... We do not know where he lives. But still the heat of summer/cooling does cause those bad caps to leak faster.

But second gens have better manufactured caps... But it would not be a horrible idea to get it tested anyways.

mcshooter
12-10-2010, 07:00 PM
how about that, stealth knows more about ecus than a 20 year mitsu mech, i did not know he is a mechanic

stealthee
12-10-2010, 07:24 PM
congrats you got lucky, but you obviously have no clue about capacitors... seriously I know your favorite reply is "OMG YOUR STUPID" but your being the dumbass. Read about "capacitors" and how they contain "electrolyte"...

PA does not have "extreme heat"... the majority of your year is fairly cool... I live right next door so I know. Cold is good for caps, high heat is not... We do not know where he lives. But still the heat of summer/cooling does cause those bad caps to leak faster.

But second gens have better manufactured caps... But it would not be a horrible idea to get it tested anyways.

mcshooter said temp extremes. Not just really hot, or just really cold was bad for ECU's. I'm not just "lucky" as you put it. My ECU is still 100% perfect. Every ECU car I have had has been near the 10 year mark and has NEVER had an issue. My Stealth was manufactered in June of 93 so its over 17 years old and there is nothing wrong.

A 20 year Mitsu tech saying "ECU's only last 10 years" is making a BROAD generalization. Just because the early gen DSM's and 3s's had issues with caps doesn't mean all cars do. So yes that is very stupid to say.