PDA

View Full Version : Jbl ms-8



2fnloud
12-23-2013, 09:21 PM
I was certain that there is a member here that uses one of these, hit me up if you read this please.

mb7050
12-23-2013, 09:34 PM
I do ..

2fnloud
12-23-2013, 09:54 PM
I am thinking about dropping my AudioControl Digital x-over (3-way) and Digital EQ (6 channel 30 band + 2 channel para-band) plus all my amps but sub. and use this for:

Amplifiers (front door, front dash, center, rears)
Timing Alignment (same channels + sub)
EQ (same channels + sub)

I have a Pioneer DVD player with the 5.1 DTS external brain, so I do not need the Logic 7.

with your experience do you think that the MS-8 will work for me?

mb7050
12-23-2013, 10:05 PM
I'm only using the ms-8 to drive my smallest speakers mids and tweeters . door speakers are amplified because I felt the ms-8 didn't have nearly enough power to drive them. and the sub of course is amplified. (active 3 way front + sub, no rear speakers)

JBL ms-8 only wants one pair of rca ran as an inputs
(it has 8 inputs but it can only handle 2 input channels at a time)

many people assume when they see it have 8 inputs that it'll be able to handle all 8 separately but thats not possible. so I don't think it'll work for you

2fnloud
12-23-2013, 10:45 PM
will have to contact JBL, I am thinking that it is just two channels so you can use the Logic 7.

mb7050
12-23-2013, 10:51 PM
yep ms-8 is only a 2 channel input system.

mendoza
01-06-2014, 03:53 PM
I run the JBL MS-8. The way it works is you provide signal from your deck to your ms-8 via 2 channel. Then the jbl ms-8 does time alignment and runs all your speakers active and if you have a center channel you could run Logic 7. The JBL MS-8 only has about 30 watts per channel so your not talking a whole lot of power. I would recommend keeping you amps and running them from the rca outputs out of the ms-8 to your amplifers. Let the jbl ms-8 run all your speakers crossover settings and time alignment. If you bypass the JBL MS-8 by running only certain speakers off of it and then a signal wire coming off the radio to another amplifer bypassing the ms-8 those speakers will have a 3millisecond delay. I can hear it and it's talked about in the manual. The MS-8 is a awesome tool if you know how to use it correctly. You can not adjust from your radios eq any longer you would want to leave that on flat so it doesn't throw off your base tune. It's the best tuning device for a car audio system if you don't have access to a RTA.

mb7050
01-06-2014, 07:42 PM
i don't think anyone would bypass the ms-8. fwiw all my speakers are controlled by the ms-8. ms-8 does all my EQ, crossover setttings and time alignment..
its just that some speakers are driven and controlled by the JBL MS-8 and some speakers are driven by an different amplifier but still controlled by the jbl ms-8.

2fnloud
01-06-2014, 07:51 PM
I would just turn the logic 7 off not bypass everything
but the amp portion is to small in wattage so I am going to pass.

2fnloud
01-06-2014, 07:52 PM
hold the bus, what speakers are the MS-8 driving....what is their ratted wattage...the speakers that is.

mb7050
01-06-2014, 08:49 PM
TS-S062PRS - Stage 4 Reference Series 2-5/8" Component Midrange Speaker | Pioneer Electronics USA (http://www.pioneerelectronics.com/PUSA/Car/Stage4/TS-S062PRS)
mids 15W rms without back chamber

TS-T031PRS (Archived) - Pioneer (http://www.pioneer.eu/eur/products/archive/TS-T031PRS/page.html)
tweeters 50w rms but they sound good

might end up getting an amp for these in the long run

2fnloud
01-06-2014, 10:35 PM
I have the pairs of these for my center:
Tang Band W23-1287SI 2"x3" Driver 4 Ohm | 264-830 (http://www.parts-express.com/tang-band-w23-1287si-2x3-driver-4-ohm--264-830)

I wonder if the MS-8's amp could do 2 Ohm? You feel that the 2-5/8" are getting adequate power?

2fnloud
01-06-2014, 10:39 PM
30 Watts @ 2 ohm.....hmmmmmm.

mb7050
01-06-2014, 10:51 PM
yeah I feel they are getting enough power. I usually listen at very moderate volume levels and I have completely sound insulated my car .. I don't hear any issues at high volume levels

fwiw I can turn on the logic 7 without the center channel and rear speakers but it seems many stuff that's out of phase in the music will disappear but with logic 7 on my sound stage seems to have a little bit better detail just some things disappear. It is a shame i can't use/shouldn't use logic 7 IMO logic 7 is one of the best features of ms-8.