PDA

View Full Version : Oil Pressure Gauge not working


FstAsVR4
10-04-2010, 11:34 PM
I am in the process of finishing up my 16g kit I fired her up today and noticed my oil pressure gauge wasn't moving so I immediately turned it off thinking shit no oil. After checking to make sure I had oil in the car I cranked it again and still nothing. I'm guessing the gauge sender was disconnected, can anybody tell me where this is?
SpdDmnVR4
10-05-2010, 12:02 AM
On the back side of the block right next to the drivers side halfshaft bracket. Should be pretty visible if you were under the car
FstAsVR4
10-05-2010, 12:11 AM
Thank you sir. Will check it out in the AM.
Atrosity
10-05-2010, 11:46 AM
Yeah it is a circle looking thing near your oil pan.
GTOJOE
10-05-2010, 09:51 PM
Also check the blue plug on top of the intake. part of a group of 3 as IIRC it's the harness for the oil pressure sensor.
green-lantern
10-06-2010, 06:10 AM
I just so happen to have a pic I used recently for a thread just like this on some lesser 3s forum.


http://i123.photobucket.com/albums/o310/hptech4564/oilsendingunit.jpg


As you can see in the red circle my oil sending unit is unplugged.