View Full Version : ECS to non ECS struts questions.
TwoXist
09-30-2010, 01:14 AM
So it has come time for me to change my struts. My issue is that I have ecs struts. If i go with non ecs struts will there be any issues with this? And if so what can I expect?
Austin@STM
09-30-2010, 01:28 AM
There wont be any issues, you just wont have 2 ecs settings anymore. It will be one stiffness all the time. Plus it cleans things up a little getting rid of the ECS struts.
TwoXist
09-30-2010, 01:51 AM
Thank you, do i need to remove anything/disconnect anything? Or just bolt them on and move about my day.
hotGTO
09-30-2010, 02:56 AM
There is a very small "motor" that plugs into the top of each strut, you just unplug it, very simple and easy to figure out by looking at it for about 60 seconds. they just pull straight off...
skater334
09-30-2010, 04:02 AM
There is a very small "motor" that plugs into the top of each strut, you just unplug it, very simple and easy to figure out by looking at it for about 60 seconds. they just pull straight off...
Unless your's are corroded like ours were, then be careful not break them. Also, look into removing your ECS Module unit. Takes 5 minutes.
blindmist
09-30-2010, 05:04 AM
You will need this...
http://www.3sx.com/faq/ecsmodule/index.asp
TwoXist
09-30-2010, 01:49 PM
You will need this...
http://www.3sx.com/faq/ecsmodule/index.asp
Thanks for that link, i was already beginning to wonder where that control unit would be.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.