Billet gears for 6spd T-case

[super95awd]

André has received the t-case cover. Now it's just matter of installation and testing!

[mehrshadvr4]

In for the installed pic

[jazz9]

I can't wait - test it already

[green-lantern]

Here's with the bearing race dropped in. I tightened up the fit about .0005" because the factory cover was a little on the loose side for me.

That is awesome!

[2fnloud]

How much thicker is this than the stock cover from the outside? My Stillen D/P is awfully close to the stock cover as is.

[green-lantern]

How much thicker is this than the stock cover from the outside? My Stillen D/P is awfully close to the stock cover as is.

No problem

[2fnloud]

your funny

[MR2]

Steve, a good question honestly, I would still like to one day (in my dreams) fit a 3.5" pipe through the TC/Sump gap

[super95awd]

You'll be fine as long as your downpipe isn't routed ridiculously. Since I counterbored the fasteners, the overall thickness doesn't come out much past where the stock fasteners did, but it is significantly thicker where it needs to be.

[Jimvr4]

Cover looks great but I don't get it. How is a billet 6061-T6 cover stronger and less flexible than the stock cast iron cover? Or is it just to increase the pre-load on the bearing?