Gauging Interest: Aluminum Lower Door trim.

[Atrosity]

I may rotate the o with the slit on the top. Been busy making the drawing for the Lower Door trims to get my prototype out.

[Nationalmilkman]

I see a pretty kickin shifter trim ring in the car. That your doing as well?

[Atrosity]

I see a pretty kickin shifter trim ring in the car. That your doing as well?

Yes, but need to make my first product available up for grabs. I have quite a few products I will be selling, tomorrow I will be getting independent status.

[Nationalmilkman]

I wanna be first on the list for a shifter ring! (price pending though) lol

[Atrosity]

This isn't my car.



Lower door trims installed in a car,this is to give you an idea. Bottom side of each door. My prototype should be done by the end of the week.

[Atrosity]

Here is the first prototype made with thin 20 gauge steel.



Logos will be on the left side. First logo will be 3000GT out of the stock font used.

Possible CF insert on the right.

[bboyalan]

The first one being made is going to say 3000GT with the diamond.

Haha I see that my first base 3000GT made its way over here Old times. This picture is actually on my wall.

FYI, the trim pieces that I installed were the smokinvr4 front speaker covers, lower door trim, and 5-sp shifter ring.

Looks great!
What type of dog is that?

She is mixed Daschund and Russell Terrier; very energetic, long, and intelligent!

[Atrosity]

Haha, I knew you wouldn't mind me posting a picture of it! The interior looked very nice and you have seen mine and how I am doing something similar except I am making the trim pieces.

You would be surprised on how little pictures there is of these door trims.

[bboyalan]

lol! You should have just asked me beforehand then! I probably have a ton saved still, but people probably have a good idea already. Good luck!

[hitman17]

Hey bboyalan, where did you get the trim pieces around the handles and dash? I took mine out and wrapped in carbon fiber, but not all the pieces came out as well as I hoped. But around the handle and buttons looks pretty good on yours.

Thanks.