Fittings for Master Cyl / Prop Valve

[DrGonzo]

I found one of my hard lines running from the Master Cyl to the prop valve is leaking really bad. I am going to switch over to some -3an braided lines but I don't know which fittings I need for the Master/Prop. I've never been good figuring out special fittings so that's where I need assistance.

Here is what I have found from Speedway motors:

US Brake System Fittings - Speedway Motors, America's Oldest Speed Shop
Straight AN to NPT Male Adapters - Speedway Motors, America's Oldest Speed Shop
AN to IFM Adapters - Speedway Motors, America's Oldest Speed Shop


I looked at the STM kit but I'm not paying $200.00 just for the two lines and fittings. I already have a Stock ABS delete. I just need to replace those two lines.

Any help is greatly appreciated!!

[dpartinvr4]

I believe STM's site says to contact them if you just need the lines, and they'll make a package for you. I just got the whole kit from them and remember that on the bottom.

[DrGonzo]

Yeah, I dropped them an email but seeing as they haven't been active on here in some time I don't know when I will hear back.

I also like to have mu options open for building the kit myself if need be.

[Intropy]

For the prop valve, 10mm x 1.0 inverted flare, like this:

Russell Performance 641431 - Russell Brake Adapter Fittings - Overview - SummitRacing.com

I think the master is the same, but can't recall from memory.

[DrGonzo]

Perfect!! Thanks for the info.

I'm pretty sure they are the same also. Going to check them by connecting the prop side to master with the stock bad lines to confirm.

[Chris@Rvengeperformance]

one of the masters is a banjo

[DrGonzo]

yeah the back side one is a banjo. I just needed to know the size - thread pitch.

[Intropy]

It will be the same - 10mm x 1.0