So who wants their ECU's "Chromed"?

[dyter]

I wire pin 67 on a switch button and it work fine

[Kx1984]

just wondering if its normal for the check engine light to randomly flash during 2step

im assuming that its flashing because the motor is knocking

[Nater3kgtVR4]

I have a four button setup for my "extra" things. Im going to wire it into one of those.
1for exhaust cutout
1for 2step
1for my white led car show lights
1for something else

Sent from my DROID RAZR using Tapatalk 2

[Kx1984]

y would u need a button for the 2 step

[dyter]

My log of Airflow Hz don't work, what wrong ?

LoadBitRaw00 and LoadBitRaw01 stay at 0,1 or 2 even at high load !

I use formul (LoadBitRaw00*255+LoadBitRaw01)* 6.29 / 64

[Nater3kgtVR4]

y would u need a button for the 2 step

So you can set your 2step and then when you are daily driving and dont want to pull out your laptop to disable it, you push the button that disables the signal.

Sent from my DROID RAZR using Tapatalk 2

[Greg E]

So you can set your 2step and then when you are daily driving and dont want to pull out your laptop to disable it, you push the button that disables the signal.

Sent from my DROID RAZR using Tapatalk 2

The switch isn't needed. Chrome only uses launch control when your TPS is > 80% (which you can adjust) and when speedo > 6 mph (which you can also adjust). I've been driving my car this way since February and it's never gone off when I didn't want it to.

[Greg E]

My log of Airflow Hz don't work, what wrong ?

LoadBitRaw00 and LoadBitRaw01 stay at 0,1 or 2 even at high load !

I use formul (LoadBitRaw00*255+LoadBitRaw01)* 6.29 / 64

Are you still trying to log thru the OBD2 table? That won't work.

MUT 00 and 01 have the addresses for logging 16bit airflow.

[Nater3kgtVR4]

The switch isn't needed. Chrome only uses launch control when your TPS is > 80% (which you can adjust) and when speedo > 6 mph (which you can also adjust). I've been driving my car this way since February and it's never gone off when I didn't want it to.

Coming from you Greg I think I will not use the switch and see how it goes then if needed add it in.

Sent from my DROID RAZR using Tapatalk 2

[Zybrainn]

I tried flashing chrome v2 to my car the other day and it errored out during the initial flash. After trying to flash again, I kept getting the following error message: "WARNING: failed to erase page at 0002C000". I could read the rom and test the flash just fine, just couldn't get the write function to work.

I tried searching but couldn't find much other than wrong processor names in the xml when this happens on people's evo's.

I have a battery tender hooked up to the battery so voltage shouldn't be a problem. I'm using Ecuflash 1.42.2595 and I also tried the 1.43 beta version. Any ideas anyone?