Engine's Out! Winter build has started

[Chris@Rvengeperformance]

Get a ball hone (if you don't already have one). It is the easiest to use deglazer/finisher and you literally can't mess up the bore with it. Spray WD-40 in the bore after you clean it. Ball hone attaches to a drill and as you spin it in the drill you push and pull it in and out of the bore. It won't take but a handful of passes to get a proper finish.



-Chris

thanks a bunch chris. This looks like the correct size and grit right? Going with sealed power rings.

Amazon.com: Brush Research FLEX-HONE Cylinder Hone, GBD Series, Silicon Carbide Abrasive, 3-3/4" (95 mm) Diameter, 240 Grit Size: Industrial & Scientific