Page 4 of 4 FirstFirst ... 234
Results 31 to 38 of 38

Thread: Cant believe im doing this...

  1. #31
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2007

    Location
    Pueblo, CO
    Posts
    1,565
    Thanks
    19
    Thanked 17 Times in 17 Posts
    ok, probably not gonna sell it. Damn didnt think everyone would be so passionate about my car and a fellow member leaving the platform. Just an update, i replaced my TCase input and output seals today and chacked the case and it looked fine. pt it all back together and car ran great. got it home in the garage, and looked under the car and had a drop under the tcaseon the ground. came back in about 20 minutes and it was a bit larger. cleaned the floor and will wait til the morning to see if its worse. looks like there might be a small crack maybe? I might have to pull off the tcase ans brace, reclean it and pull all the housings apart and check for cracks. this is what im takling about. Never fukin ends. Wish i had another tcase to try to see if its my tcase or something else. It never ever leaked before until the tranny was taken out. but i know its the tcase becasue the tranny was ful and the tcase level was very low. so it has to be coming from the tcase. ugh........

    1/4 mile 11.80 @117mph. 551whp 641trq @ 26psi E85 tune, MTC 19T-HLs, forge 15psi spring wastegates, 780 PTE inj, 3SX Fuel loop, ss fuel lines, Engine built by Laniers Speed shop, block bored .060 w/ chromolly rings, weisco pistons, 3sx custom forged rods, forged crank, HKS DLI, AEM EMS, AEM UEGO wideband, prosport oil and boost guages, aeromotive 1000 FPR, Dejon blow thru twintakes, Walbro E85 400 w/ 3sx hotwire kit and custom an fitting fuel pump w/ STM filter to pump line, CXRacing FMIC, Megan Racing Aluminum radiator, IPS custom downpipe, Borla 3" exhaust,Greddy profec b spec II EBC, Blitz SS BOV,R1 Drilled slotted rotors, Drag DR-31 rims, RPS stage 4 unsprung clutch,

  2. #32
    TD04 Upgrade & Billet TD05 Upgrades
    Join Date
    Sep 2010
    Owner Since
    2005

    Location
    Hudson, WI
    Posts
    696
    Thanks
    26
    Thanked 23 Times in 13 Posts
    Hopefully its not the case! I think we may have a spare T-case laying around if yours ends up being cracked. You could just swap over your internals and brace to our spare one if need be.

  3. #33
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2007

    Location
    Pueblo, CO
    Posts
    1,565
    Thanks
    19
    Thanked 17 Times in 17 Posts
    how much? i really think its the case. had a puddle under it this morning starting to smoke a little on decel too. 309 miles! ugh

  4. #34
    TD04 Upgrade & Billet TD05 Upgrades
    Join Date
    Sep 2010
    Owner Since
    2005

    Location
    Hudson, WI
    Posts
    696
    Thanks
    26
    Thanked 23 Times in 13 Posts
    I dont really know what t-cases go for. 100 bucks plus shipping? Idk if thats a good deal or not, feel free to make an offer if you think thats too much.

  5. #35
    VR-3747 :D Not Verified
    Join Date
    Sep 2010
    Owner Since
    2008

    Location
    Dayton Ohio
    Posts
    1,792
    Blog Entries
    1
    Thanks
    19
    Thanked 123 Times in 86 Posts
    i got my transfer case for $300 and it was freshly rebuilt, new seals and all. $100 or a little less i would assume is about right.
    rise and rise again until lambs become lions

  6. #36
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2007

    Location
    Pueblo, CO
    Posts
    1,565
    Thanks
    19
    Thanked 17 Times in 17 Posts
    ummm dan, hows the seals? any leaking since i just friggin installed these new ones in this turd. lol how much shipped? ill probably take it if its pretty decent.

  7. #37
    TD04 Upgrade & Billet TD05 Upgrades
    Join Date
    Sep 2010
    Owner Since
    2005

    Location
    Hudson, WI
    Posts
    696
    Thanks
    26
    Thanked 23 Times in 13 Posts
    Mike I honestly cant tell you how the seals are on the spare one because I never had it on a car. Its just a 25 spline that you could use the case on if yours is cracked, as far as I know the internals are all good and there are no issues but I never ran it or took it apart so I dont know. For the one that I dont know seal condition on I'd think like 25 bucks should cover shipping.

    I do have one that I replaced by Mitsu about 20k miles ago that was supposed to be for my race car but I am never going to have time to build it so I'd probably be willing to sell that one too, but that one I'd want a little more because it was replaced at one point. I guess based off what futureman bought his rebuilt one for and this one not being brand new being its got 20k miles on it hows 225 plus 25 for shipping sound? Again I'm not trying to make a killing so if you think thats a fair price then cool, if you dont just let me know what you think is fair.

  8. #38
    Forum User Not Verified
    Join Date
    Sep 2010
    Owner Since
    2007

    Location
    Pueblo, CO
    Posts
    1,565
    Thanks
    19
    Thanked 17 Times in 17 Posts
    $200 shipped? and ill send you some new dyno graphs

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The 3000GT/Stealth/GTO Web History Project
3000gt.com
3000GT / Stealth International WWWboard Archive
Jim's (RED3KGT) Reststop
3000GT/Stealth/GTO Information and Resources
Team 3S
3000GT / Stealth / GTO Information
daveblack.net
3000GT/Stealth/GTO Clubs and Groups
Michigan 3S
MInnesota 3S
Wisconsin 3S
Iowa, Nebraska, Kansas 3S
North California 3000GT/Stealth
United Society of 3S Owners
3000GT/Stealth/GTO Forums
3000GT/Stealth International
3000GT/Stealth/GTO Event Pages
3S National Gathering
East Coast Gathering
Upper Mid-West Gathering
Blue Ridge Gathering