(of course I can search this but the site needs content)
Has anyone had any of these, and why did they stop production?
They work well for VR4s?
(of course I can search this but the site needs content)
Has anyone had any of these, and why did they stop production?
They work well for VR4s?
Do you mean Sanor / Quickor stopped making them?
If so, bummer.........
In for response...
I have tried and run both PST brand CFDS on my 97' VR4. The single shaft nor present two piece shaft install ever made contact with my rear mount Saner sway bar; there is indeed a very small margin of clearance though! The clearance challenges others have reported/experienced might be attributable to slight variance in the sway bar mount point? I never had need to investigate but possibly there is sufficient movement to allow the sway bar to be pushed upward a small margin before torquing down the mounting bolts - is the only explanation I can surmise?
Dan
97VR4
I think the biggest problem people have had with contacting the sway bar with the driveshaft was probably under launch conditions, where the driveshaft wants to try and shift due to the sudden load applied to it.
3000gt.com 3000GT / Stealth International WWWboard Archive Jim's (RED3KGT) Reststop |
Team 3S 3000GT / Stealth / GTO Information daveblack.net |
Michigan 3S MInnesota 3S Wisconsin 3S Iowa, Nebraska, Kansas 3S |
North California 3000GT/Stealth United Society of 3S Owners 3000GT/Stealth/GTO Forums 3000GT/Stealth International |
3S National Gathering East Coast Gathering Upper Mid-West Gathering Blue Ridge Gathering |
Bookmarks