HHH log check

[iceorphen]

Just wanna know if my logs are OK. As in nothing far off from the norm, the rear o2 is being logged, even though there is a cut wire on the connector leading into the o2 harness (on engine harness, not ON the o2 harness)

Cold start / warm up session file
startup.session

CSV link on google docs
https://spreadsheets.google.com/ccc?...thkey=CL_UspkD

Warm idle/ revs session file
idle_rev.session

CSV link on google docs
https://spreadsheets.google.com/ccc?...thkey=CLDp65sJ


thanks in advance

[x2xtreme360]

Responded over on the other site too... but basically you should do a pull and log that. The log you have here looks normal but there's no pushing of the engine involved.

[iceorphen]

Ok thanks, ill try and get a pull log today, if not today then next week :/

[iceorphen]

Quick pull from 1st thru most of 3rd.
Im mainly concerned with the timing and if the o2 sensors are displaying a typical readout for the work they're doing.

Also when i log the fuel trims, i get no data, is that normal?

Session file
test_pull.session

CSV on google docs
https://spreadsheets.google.com/ccc?...thkey=CIfIr_AB

thanks again!

[iceorphen]

Bumpy