What did you do today to your 3/S?

[DuTTch]

Come on Mark, you know you wish you were going. Maybe you can come by and help me get mine ready when I get the body parts back?

body parts are hard to install, but I will drink some beer and keep you company lol. I can hand u tools

[DuTTch]

just ran a boost balance tube from turbo to turbo. hopefully finish my killerglass install when my heat shrink clamp gets here. took my new shaved plenum(my custom one leaks now, 1k down the drain) to machine shop to have it bored to 70mm,lop off the egr thingy and weld it shut.

I sure hope it isnt the stock plenum cause the out side of the intake on the oem plenum is only 68mm lol

[Boomer3000]

Fixed the miss fire issues... Now for the exhaust!!!

[DuTTch]

I tried to pick up my greddy wire harnasses for my my gauges but they send one back to greddy, whaaaaatttttt? wtf

2nd I tried to pick up me reupholstered altered dash and that was not ready pfffffff

That was enough negativity for the day

[mb3000]

Got up early and did some cutting.
Before:


After:

[Valhallaz]

Got up early and did some cutting.
Before:


After:

IMO, that cut would look better if it were the width of the lower part of the opening with a much bigger curve at the upper corners. Just my two cents.

[dpartinvr4]

IMO, that cut would look better if it were the width of the lower part of the opening with a much bigger curve at the upper corners. Just my two cents.

I did that to my second gen bumper...it looks like a cat fish go to 3sfail and look for a thread called "damn you scuba steve" before you try that

[shmoo]

Got up early and did some cutting.
Before:


After:

cool. did you remove the bumper to cut it?

_isiah

[Polygon]

Fixed the ECS and if FedEx would get here I could fix the shifter linkage too.

IMO, that cut would look better if it were the width of the lower part of the opening with a much bigger curve at the upper corners. Just my two cents.

I have to agree.

[mb3000]

IMO, that cut would look better if it were the width of the lower part of the opening with a much bigger curve at the upper corners. Just my two cents.

That is the height/width of the actual cooling fins, I want air going through the ic not around it.

I'm going to make some ducting, eventually.

cool. did you remove the bumper to cut it?

_isiah

I left it on the car & used a little Skill saw for the cutting.