What did you do today to your 3/S?

[NickS VR4]

Cleaned garage and pushed car back in, since I can't paint outdoors in the cold weather. Next week will be rattle-can primering the engine bay, then sanding and base coating and clearcoating it w/ rattle can. This is experimental. If it turns out good, than I'm set, if not, I'll have to just pay someone to do it.

[CoreyB]

What color are you doing Nick?

[NickS VR4]

Danube Blue

[CoreyB]

Ah ok, sweet. If you go to Napa, they can actually put that into a spray can for you, actual automotive paint. At least the one here can, if you want I could have it done and ship you a couple cans if your local one doesn't do it.

[NickS VR4]

Ah ok, sweet. If you go to Napa, they can actually put that into a spray can for you, actual automotive paint. At least the one here can, if you want I could have it done and ship you a couple cans if your local one doesn't do it.

Thanks. I have one can with it, and it was about $25. I was going to start with that. (Auto Touch Up Paint, Automotive Touch Up Paint, Car & Truck Touchup Paint: Acura, Honda, Toyota & More.). I'll contact the local NAPA and see what they charge... probably a better quality paint with them.

[Sin'sVr4]

drove it yesterday and did some spirited driving to the gym. Then parked her again. too much sand from the snow and got loose a few times. roads were clear and dry, just the residual sand sucked

[anyonebutme]

started tearing it apart again...

[Chris@Rvengeperformance]

haven't done a ton of work on the cars because I've been working on this:

[Street_Chally73]

haven't done a ton of work on the cars because I've been working on this:

I spy a pressure tester...

Very nice looking setup!!


Sent from the garage

[JGreenwood238]

This was from a couple weeks ago but figured I'd share, just after replacing my lifters and doing my 60k I went out to an autocross event.. So much fun! The guy doing the laptimes asked me if it was a vr4 lol.