What did you do today to your 3/S?

[Chris@Rvengeperformance]

yeah, I guess the unfortunate part for some research purpose is that I'm not going to chase anymore power from 93. With my stock shortblock it isn't worth the risk of breaking a piston and wiping out my turbines to me. MAYBE I could hit 500 like this, but the other thing is doing more and more pulls on the street isn't without risk.

[GTOJOE]

Installed this. EVO 4, 5 & 6 MOMO wheel. All the research I have done pointed to the fact the airbags is compatible but after installing the SRS light is on



Sent from my GT-I9300 using Tapatalk 2

Found another member using this exact same wheel. He had no issues with the SRS light so I suspect my SRS unit had some residual power in it and detected that I unplugged the airbag. Will somehow clear this light and then leave the battery disconnected for a while to drain all residual power and try again.

[IPD]

i'm not gonna lie. i kinda want one. dunno if i can live without cruise though.

[fastfalcon94]

Finally got my transmission back from pampena motorsports and wasted no time putting it in. I managed to do it myself with an engine hoist. I took it for a spin for the first time this year. Now that it is off the lift I was able to get my crappy sailboat inside for some much needed TLC

[CoopKill]

Made it roll!

[TurboSinceBirth]

I took apart a 5-speed to get my center diff core sent out I've procrastinated on. The Quaife diff looks good so that'll get swapped over. I have two more transmissions to take apart which I may do tomorrow.

[stealthee]

i'm not gonna lie. i kinda want one. dunno if i can live without cruise though.

You can keep cruise. You just have to set up the switch differently.

[BucknVr4]

Test fit the DP. Found out the rear pre-cat elem is for a 1st gen so no way that's going to work. Can't get the from pre-cat to mate up but that may be because of dealing with trying to line up all of the studs by myself. If I could pull the studs off of at least one thing them I might be able to try it. Soaking in PB Blaster now. I was able to mate up the front pre-cat elem though which is what I'm sure I'll use but I have to put a lot of stress on the DP to get it to line up. I'm thinking about having a flex section put in the front tube.

[FeaRpb]

I did this.

[GTOJOE]

i'm not gonna lie. i kinda want one. dunno if i can live without cruise though.

You can keep cruise. You just have to set up the switch differently.

I plan on doing this at some point. Either mount the original switch somewhere or just fit another switch. Not enough room on the evo wheel to mount the stock one but maybe a smaller one could be done.

I Also tried the old turn the ignition on and off 10 times trick but no dice. Still light on.

Sent from my GT-I9300 using Tapatalk 2