Super, Super sale: 4340 Forged H-Beam 6G74/6G75 rods

[BaadVR4]

Almost desperate to sell six sets of these rods. Here's the link to my original thread:
http://www.3sgto.org/f62/super-sale-...pped-1629.html

I will let these go for $495/set shipped in the US. $530 shipped to most international addresses, but PM for confirmation. I will do $475/set shipped for orders of two or more sets. Will also consider reasonable offers. PayPal is milton_goldin@hotmail.com.

[gs1000kat]

This sale only applies to the 6g74/5 rods, not the 6g72?

[BaadVR4]

This sale only applies to the 6g74/5 rods, not the 6g72?

Correct.

[BaadVR4]

To the top.

[BaadVR4]

To the top!!!

[BaadVR4]

To the top!!

[MR2]

we never had much luck on the 75 pistons did we

[BaadVR4]

we never had much luck on the 75 pistons did we

Well, depends. The pistons are easy enough to get from Ross, they're just pricey. As in roughly $950 with pins/rings,plus shipping. If someone wanted a set of rods and pistons, though, I'd do $1375 plus shipping. I'd have to check whether or not I can get them all into one USPS Large Flat Rate Box, which would make shipping about $25-30 in the US and about $50-60 overseas, including insurance.

[MR2]

Well, I already have your rods so these are the pistons that have the downset for the 75 crank? unfortunatly I'm another problem in that I have the 75 mivec heads...that have an increased CC capacity...different than the 74 heads, I found the total CC somewhere if you want it?

[BaadVR4]

Well, I already have your rods so these are the pistons that have the downset for the 75 crank? unfortunatly I'm another problem in that I have the 75 mivec heads...that have an increased CC capacity...different than the 74 heads, I found the total CC somewhere if you want it?

Ross would probably need that info to make the pistons. Which block are you putting this set up in?