Spark plug gap with HKS twin power DLI

[Ninja Performance]

I always run 26 even with the Twin Power. But I also run 36psi so...

-Chris

[J. Fast]

Are you running Copper 7's IPO?

[mb7050]

Where did you buy the relay from? Do you have any manufacture or model #'s? Any installed pics?

sorry no model #´s
but its just a 50 amp bosch automotive relay(30amp will do).Decided to go with basic automotive relay so that incase of a failure I could easily find a replacement, you can find them at every gas station
and a plug very similar to this for the relay


here is some installed pics.

normally you cant see much because its all under the air intake box..
IMAG0218.jpg
I made a little bracket for the DLI and relay
IMAG0221.jpg

[Ninja Performance]

Are you running Copper 7's IPO?

NGK copper 8 non projected, ethanol likes non projected plugs. As does high boost.

-Chris

[kywhitelightning]

I run .030" at 24-25 psi without issue with the DLI. I'm not sure if I would even try .032" because I did a lot of gap testing before I found .030" to work great for my setup. That and the fact that you are going to want to run more boost later anyway.

Jeff