Hello all,
Can you tell me if it is possible to change the control parameters of the Custom Pin 35 Output of the Chromed ECU?
I want to use it to switch a magnetic decoupler to the front prop (project car) when certain conditions are met; brake light switch, handbrake switch, speed etc.
I'd need it activated above a certain rpm but no load from the start line 4wd. (rpm trigger maybe but no load)
Deactivated for high speed cornering to reduce understeer (so lower load).
Activated out of the corner for traction (higher load)
Deactivated under braking. (no load)
Deactivated with handbrake. (relay cut maybe)
Maybe I could use a spare input (even if only an on/off 5v) as a steering angle input?
Can i edit the XML so that the TPS greater than rather than less than? (that way the launch control feature would give me a high TPS for start)
BTW, decoupler I'm thinking of is from A Mitsu Outlander (same unit as on the Jeep Patriot and other marques). I believe this is an on/off decoupler rather than a current controlled variable rate clutch you'd find in aSubaru perhaps.
Bookmarks