Renegade TechWorks ECS Model03 Auto Mode Suspension Controller

[2fnloud]

Also after looking could you daisy chain a typical USB type A to type B chord to a A Female/B Female Adapter to the cable for firmware flashing? IF so I can make an access port in the hatch, and just connect the USB type A to type B chord to the A Female/B Female Adapter, and my PC.

[duke3k]

Also after looking could you daisy chain a typical USB type A to type B chord to a A Female/B Female Adapter to the cable for firmware flashing? IF so I can make an access port in the hatch, and just connect the USB type A to type B chord to the A Female/B Female Adapter, and my PC.

yes you should be able to leave the cable plugged in and use an extension cable if its not too long.

[2fnloud]

Would like to make an access port in one of my trim panels for flashing or whatever:



Kind of a pain to remove that panel.

[2fnloud]

Order placed!!

[duke3k]

Order placed!!

Got it & Just sent you a response email.

Thanks for the order!

duke3k

[duke3k]

Got it & Just sent you a response email.

Thanks for the order!

duke3k

@2fnloud - Just finished building out your unit - here's a pic. Yours is the 18th Model 03 to be shipped. Calibration completed and all post build tests check out ok. Next is a 24 hour burn in of the entire unit and it'll ship on Monday.
IMG_5949.JPG

[2fnloud]

@2fnloud - Just finished building out your unit - here's a pic. Yours is the 18th Model 03 to be shipped. Calibration completed and all post build tests check out ok. Next is a 24 hour burn in of the entire unit and it'll ship on Monday.
IMG_5949.JPG

AWESOME! Should be a quick swap, looking forward to it.

[2fnloud]

I built my cable to integrate into the car. Can you flash the firmware without the brain being connected to the car? What software is to be used? I didn't see links on your webpage

[duke3k]

I built my cable to integrate into the car. Can you flash the firmware without the brain being connected to the car? What software is to be used? I didn't see links on your webpage

By building the cable to integrate -You mean the firmware extension cable right?

Yes you can flash the firmware with out the controlller being installed in the car. To flash the firmware you just use the Arduino Opensource IDE... but you need some libraries installed to do the flash. I'll post up the libraries and some instructions.

You have the most current firmware version and I don't necessarily have any updates in the works - everything seems to be working fine with the current version.
Of course since I provide the complete source code to the firmware you could always hack away at the controller.

duke

[2fnloud]

This: ARDUINO 1.8.2?