Quote Originally Posted by jpinvictus View Post
Awesome! So, there's not a specific torque rating I need to worry about, right? Just tighten it down?

And there's nothing I need to loosen or open when bleeding? Should I leave the cap off the resevoir?

Sent from my SM-N910P using Tapatalk
There's a torque figure, but you'd be VERY hard pressed to get a crow's foot wrench and a torque wrench anywhere near that fitting. I'd personally go a bit tighter than "snug" with a wrench, but it's definitely a feel thing.

I'd leave the cap off because you're going to need to add fluid. Maybe put a rag over it if you're worried about spillage.