Swapping Odometer's between gauge clusters

[Beef6]

I bought a TT gauge cluster to install my LCDBC screen and put into my TT swapped Stealth. Is it possible to swap the odometer from my current gauge cluster into the TT one? I haven't torn either apart yet but if I cant swap the odometer to reflect the true mileage I am not going to bother installed the LCDBC in it.

Thanks
Josh

[j2k4]

I had the same dilemma; what I did was take a pic of the new cluster - with LCDBC in place - in front of the original cluster (in place) so as to show both mileages at the point I swapped clusters, to document the difference, which in my case was 14,963 miles.

I didn't want to do without the LCDBC.

I have the original cluster stashed as supporting evidence.

[Uniuno]

If you're careful you can take the number spool out and set it to whatever you want.

Ask me how I know

[Beef6]

Define really careful haha

I much rather set the TT fairly close if I can instead of tearing two apart and hoping it works after.

[DocWalt]

It's tedious tiny work but any mechanical odometer can be tweaked to suit your needs. I'm not condoning rolling it back to under the car's actual mileage, though I know that's not what you're after

[2fnloud]

It is very easy to pull out the odo part of a cluster and put it into a donor cluster.

My car has 32,xxx original miles and I couldn't bear the thought of cutting up the original cluster to install the LCDBC screen, so I had in installed into another cluster that I swapped my odo into.

[futurevr4man]

I don't think it's difficult to set the odometer to whatever you want. The clear plastic and black trim bezel are a bit brittle cause they're all old at this point

I reset my odometer on my car cause I wanted to know where I start from since it's a new build. The title will still track the mileage on the car... not that it will matter

[Beef6]

Sounds good, hopefully I can just adjust the TT cluster without breaking it. Ill give it a go tonight.

[Beef6]

Pulled apart the TY cluster, turns out the odometer assembly is easily removed with 4 screws. I am assuming the one from my car will swap right over. Well I hope that's the case anyways, going to start measuring and cutting up the TT one to mount my LCDBC screen.

[2fnloud]

Told you it was easy.