I finally got around installing the ACPT driveshaft that I had laying around.
weird thing is that its removed from 1995 vr-4 and I´m installing it to my 1996 vr-4 so what is wrong.
mounting holes are all wrong
and its this much too long.
I finally got around installing the ACPT driveshaft that I had laying around.
weird thing is that its removed from 1995 vr-4 and I´m installing it to my 1996 vr-4 so what is wrong.
mounting holes are all wrong
and its this much too long.
Last edited by mb7050; 10-11-2010 at 01:13 PM.
it turns out I have wrong rear adapter .
Ahhhh
Building a House, Car Mods on hold!
1996 GTO, Owner since 2003.
Another thing, it looks like the shaft is not made to replace the whole drive shaft (one piece). Hold the end up to the rear dif and see if the front matches up to the 1st carrier bearing.
its supposed to replace two first sections .
3000gt.com 3000GT / Stealth International WWWboard Archive Jim's (RED3KGT) Reststop |
Team 3S 3000GT / Stealth / GTO Information daveblack.net |
Michigan 3S MInnesota 3S Wisconsin 3S Iowa, Nebraska, Kansas 3S |
North California 3000GT/Stealth United Society of 3S Owners 3000GT/Stealth/GTO Forums 3000GT/Stealth International |
3S National Gathering East Coast Gathering Upper Mid-West Gathering Blue Ridge Gathering |
Bookmarks