The car is a 1994 VR4. First off ill start with the mods and things that may be related to it. I have a Emanage ultimate spliced in and the injector adaptor wired in. Both are wired in correctly as far as i know. I do notice that many wires in the harness were previously cut into or im finding some exposed
This started a few months ago. I usually only happens around operating temp but stops after a few minutes of driving. If the car is just idling, the rpms will surge and act stupid for a second then the car will kill. If im driving, it will die but the car will start back off based on the momentum of the car continuing to travel forward. It does throw a CEL and here are the codes:
code 22 - crank angle sensor - When all this first started, i replaced this with a brand new one. The code came back and theirs no way this new one is bad again. It has maybe 5 miles on it.
code 23 - cam angle sensor
code 41 - injector fault - was supposed to be corrected by the greddy injector adaptor but apparently not
Please help before i break down and buy a new engine harness (which i might do anyway considering all the wires cut into/ broken), A boomslang harness for the EMU so i can be sure it wasnt wired incorrectly, and maybe even a new ecu
Bookmarks