oohnoo - Large SMIC's

**oohnoo** · 08-11-2014, 03:48 PM

Looks like we're finally ready to Rock-n-Roll

In response to my thread for the large SMIC's I'm proud to offer these to the community. These intercoolers are made from BELL cores with a size of 8" x 4.5" x 8.1" with a cfm of 683 per core, along with custom end tanks that I designed. With these intercooler you'll be able to use your stock ducting and I've also included some custom brackets to move the oem oil cooler back and down a little for clearance.
There's a couple of things you will have to do to make these work on your car. First is the ABS bottom shield has to cut for clearance for the upper pipe. This is thin material so it's easy to cut. I haven't tried it as I already cut mine but you might be able to just bend it out of the way. Actually I can test it on my '97 once I fab up the next set. The other thing is you'll need to transfer the rubber isolators off your old side mounts to these new ones.
With these intercoolers there are many pipe options I would like to offer. But basically these are what I have come up with. Anything else you might need please don't hesitate to ask.

Now...on to the pricing. I'm going to offer these with an initial 15% discount for the first 15 units. I'll be updating the list accordingly.

I'll be listing the pricing with the difference piping options but all come with the same Bell cores. Pricing does not included shipping. I will calculate that at time of shipping based on zip as prices vary to much with the weight of the box.

All kits have piping configuration like oem...see pic below.

Kit 1: 1 3/4" piping (used with DNP) - New Price +10% = $1045

Kit 2: 1 3/4" piping with 1 5/8' reducers welded on for oem setups or CXRacing setups) - New Price +10% = $1112

Kit 3: 2" Piping - New Price +10% = $1112

For right now I want to get a list going. I'll have to figure out the turn-around but I'm hoping to make at least 1 or 2 per week as I do have to keep the wife happy

I will require a $500 deposit with balance due at time of shipping. I will only be taking deposits for 3 orders at a time when I'm ready to start your order. So first come first served with no worries.

1:
2:
3:

**CoopKill** · 08-11-2014, 04:32 PM

He fixed it!

**oohnoo** · 08-11-2014, 04:34 PM

I fixed it...Just sign up

**vTaKwiTHsLiCkS** · 08-11-2014, 06:48 PM

Sign me up for the 2 inch please.

Please PM or post payment stuff. I didn't see a paypal address up there.

**oohnoo** · 08-11-2014, 07:04 PM

You want 2" piping like the 1 3/4" as shown above without any reducers? You will have to enlarge the opening on the drivers side where it comes up by the AC dryer. If you want I can put a couple mid section of the long pipe for some flexibility as the cost for it is minimal

**vTaKwiTHsLiCkS** · 08-11-2014, 07:21 PM

I believe so. I'm assuming the enlarging wouldn't be too much more than what the older style FMIC piping required? That would be awesome.

I believe you mentioned the DNP piping is 2 inch that tapers down to 1 3/4 for the sidemounts right? I'm planning on copying my DNP kit but keeping it 2 inch the entire way. 700AWHP on DR750s or BUST! Hopefully the former and not the latter.. lol