Page 1 of 2 12 LastLast
Results 1 to 10 of 20

Thread: Parting out a Modded 97 VR4, arc2, defi gauges, rps clutch setup, 3sx motor etc..

  1. #1

    Parting out a Modded 97 VR4, arc2, defi gauges, rps clutch setup, 3sx motor etc..

    Edit: Only parts listed below are for sale. Everything else on the car is scrap and no longer available.

    I acquired a wrecked 97 vr4 a few days ago. It was owned by a local guy that I knew of, just never really met until buying the car. He posted it on a local facebook car/swap page. He really didn't know much about the car, he just drove it. Last fall he lost control in a round about and totaled the car. I saw it had a lot of nice stuff on it so I bought it to part. Doing some research (by searching the vin# )I was able to track it back to this sale add.

    3000GT/Stealth International Message Center

    You can see back in 9/24/2010 the car only had 66k miles on it. All mods were done after 63k miles. It currently has 69k. I've already pulled everything off the car that I think is valuable. Some items I'm keeping for myself. Some items I think may sell to some of my local friends. Everything else is getting scrapped sometime this week.

    Located in Milton, Vt 05468.
    802-309-9978
    Paypal is fastfalcon94@gmail.com

    Also I live about 40 minutes from the closest shipping center (Fedex) and about 12 minutes to the closest post office. So I like to ship stuff once a week on Thursdays.




    Stuff I'm keeping for now...
    -----------------------------
    New OEM transmission AWD 6 spd 25-spline as spare
    Rear trailing arms as spares
    PST Carbon Fiber Driveshaft to try out
    6 speed shifter assembly/cables as spare




    Stuff For Sale
    ------------------------------


    - OEM Red hoop wing. A little faded but can be buffed back to life - 100 plus shipping
    - fuel pump assembly - $40 shipped
    - rear axles 125 shipped (I have probably 3-4 sets of these and don't need that many spares)
    - rear 6 speed diff 240 shipped
    - 97 vr4 ecu w/ 69k miles - $100 shipped
    - black dash part stuff (dash with good non-broken vents, pillars, kick panel, glovebox,) May be able to separate ship some stuff. No airbags as they deployed - 80 pickup only




    Sold
    ------------------------------
    - digital climate control conversion kit. I've sold 3 of these in the past and know what to pull. Screen itself works but one of the mounting tabs is broken. -170 shipped
    - stock turbo intake pipes and intake bubble - $30 shipped
    - 6 speed transfercase - 240 shipped
    - RPS Street max clutch, lots of life left - 290 shipped
    - Fidanza Aluminum Flywheel - 240 shipped. Will do $500 shipped for clutch/flywheel package.
    - ARC2 Fuel controller w/3.5” MAF - 480 shipped (can include center console thats been modified for it if you want)
    DRIFZ Nos (505B) 18inch rims/tires - 225 - SOLD Locally to friend
    - HKS Super Sequential Blow-Off Valve w/ intake bubble adaptor - 70 SOLD
    - AEM 52mm wide (both wire harnesses, and sensor are there. No o2 bung but I think I have an extra one in my supply I could include if needed) - 70 shipped SOLD
    - 69k mile gauge cluster - $35 shipped SOLD
    - Rear 2g calipers - $135 - SOLD
    - black carpet w/ side pieces (Never seen oem black carpet before. Very nice) - 150 plus shipping - SOLD
    - Newer dome light with homelink - 50 shipped - SOLD
    - JVC AVX-810 dvd/touchscreen radio. Has add on ipod adaptor, and add on bluetooth module. Also includes aftermarket SWIX box so steering wheel controls work - $300 shipped ~ Pending locally, SWIX may be availale - SOLD to guy at work, keeping SWIX
    - 15g Turbos (front turbo is good, rear has some marks in compressor wheel and some in/out play. I'd get it rebuilt) - 400 shipped for both
    - Dn rear Pre-Cat Eliminator 120 shipped - SOLD
    - Defi BF gauge package. These gauges look so awesome. Pictures of defi gauges online don't do them justice. Really cool to see them in person. Comes with Control Unit II DF05002,Defi BF boost guage DF04304, Defi BF oil pressure guage DF04404, and Defi BFwater temp guage DF04704. All wiring, boost/oil/temp sensors there. The controller still has plastic cover on the buttons that you are supposed to peal off when it's new. - $600 shipped - SALE PENDING
    - Front 2g calipers that have been hit with angle grinder a little to clear some wheels. - $80 shipped - SOLD
    - steering wheel - SOLD
    -- 3sx built 4 bolt motor (Ross Pistons TT 93mm 8.5:1, 3sx Custom forged rods, Clevite rod/main and thrust bearings, new oil pump/timing parts, 99 lifters, swirl
    polished 3sx valves). The previous owner had put around 3k miles on the car before wrecking it. Radiator was damaged during wreck so it leaked out all the coolant. Passenger tire was also rubbing pretty well on the bumper. But I still jumped the vehicle at his house and drove it on the trailer/off the trailer. I also drove it about 300' into my garage. I didn't let it run for more than a minute because of lack of coolant. I have a video of me starting it and running if I can get photobucket to upload it. Had good oil pressure, no noises. Also a cold compression test shows numbers range from ~ 147 to ~ 157. Oil cooler is still attached but lines are rusted and I wouldn't trust them. Oil pan also has a slight dent in it but not that bad. Oil pressure sensor and coolant sensor are missing as it had defi gauges installed and the sensors need to go with the gauges. Lower timing cover is broken around motor mount area. Top timing covers look like they were painted yellow at one point, then black. Someone sprayed rear valve cover black but it's flaking off. Pickup Only. - $2000 - SOLD
    - 550cc injectors (He listed them as denso, they look like RC to me without stickers) - 225 shipped - SOLD
    - Greddy Profec B SPEC II electric boost controller - 200 shipped
    - Borla Cat-Back - 400 Local Pickup Only
    - exhaust manifolds - Front one has had the common crack welded, rear one is some aftermarket one 50 shipped
    - walbro - $40 shipped


    Pics


    Car before wreck



    And afer



    Last edited by fastfalcon94; 08-16-2014 at 08:47 AM.

    Built motor, DR750s, AEM and Meth
    http://www.802projects.com

  2. #2
    Last edited by fastfalcon94; 06-14-2014 at 10:27 PM.

  3. #3




    Last edited by fastfalcon94; 06-14-2014 at 10:27 PM.

  4. #4














    Last edited by fastfalcon94; 06-05-2014 at 01:16 PM.

  5. #5


    Last edited by fastfalcon94; 06-14-2014 at 10:28 PM.

  6. #6

  7. #7
    VR-3747 :D Not Verified
    Join Date
    Sep 2010
    Owner Since
    2008

    Location
    Dayton Ohio
    Posts
    1,792
    Blog Entries
    1
    Thanks
    19
    Thanked 123 Times in 86 Posts
    dibs on the whole interior. where do you live?
    rise and rise again until lambs become lions

  8. #8
    Georgia, VT. The interior is not a complete black interior. The dash, A pillars, glovebox, steering wheel etc... was black. For some reason it had charcoal door panels though, charcoal center console. The rear B pillars looked painted. The carpet is nice and black. The seats were tan and had wear. All I can think of is that at one time the car had a black with tan interior and someone was trying to slowly convert it to all black.

  9. #9
    VR-3747 :D Not Verified
    Join Date
    Sep 2010
    Owner Since
    2008

    Location
    Dayton Ohio
    Posts
    1,792
    Blog Entries
    1
    Thanks
    19
    Thanked 123 Times in 86 Posts
    didnt realize you lived that far away lol. nevermind!

  10. #10
    The Panda Not Verified
    Join Date
    Sep 2010
    Owner Since
    01/11/06

    Location
    Washougal WA/Portland OR
    Posts
    686
    Thanks
    86
    Thanked 37 Times in 28 Posts
    I want the carpet and side carpet. Price shipped to 98671

    Ported heads, IPS 2mm oversized valves, Delta 264/272 cams, 3SX High rev valve springs, 3SX cam gears,
    Merkel 6g72 3.5L BILLET crank stroker (going in this summer), 3sx poly motor mounts
    IPS EvoIII turbo kit, HKS SSQV bov, ETS anodized FMIC, AEM intake filters, Tanabe Turbo Back Concept G Blue Exhaust,
    HKS DLI, Ultra spark plug wires, Denso iridium IK24 spark plugs,
    JSPEC trans, Ultimate Performance short throw shifter, Spec carbon twin disk clutch, PST aluminum 2 piece drive shaft,
    Denso Supra fuel pump, RC 750cc fuel injectors, AEM Fuel pressure regulator,
    AEM wideband & boost gauge, AEM EMS in speed density,
    Addco sway bars, DBA 4000 drilled & slotted rotors, Enkei PF01 18x9 +45, BFGoodrich g-froce KDW 245/40/R18

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
The 3000GT/Stealth/GTO Web History Project
3000gt.com
3000GT / Stealth International WWWboard Archive
Jim's (RED3KGT) Reststop
3000GT/Stealth/GTO Information and Resources
Team 3S
3000GT / Stealth / GTO Information
daveblack.net
3000GT/Stealth/GTO Clubs and Groups
Michigan 3S
MInnesota 3S
Wisconsin 3S
Iowa, Nebraska, Kansas 3S
North California 3000GT/Stealth
United Society of 3S Owners
3000GT/Stealth/GTO Forums
3000GT/Stealth International
3000GT/Stealth/GTO Event Pages
3S National Gathering
East Coast Gathering
Upper Mid-West Gathering
Blue Ridge Gathering