First Datalogs on new engine. Need input.

[blindmist]

Ok, so I finally had the time to get some real datalogs. 40 mins worth or so.

They can be found at http://www.jslaydesign.net/datalog

For use with HHH. Please let me know how these look. Thanks!

Also, it would be nice if someone can point out what I should be looking at in these things. Never really gone this advanced before.

Edit:

I have 3sx Ross 8.5:1 3sx Rods and a Forged from a 4 bolt in my 2-bolt.
stock 360cc's and a hotwired with lo-hi Walbro 255.
13t's at 12psi on the autometer, don't know how accurate it really is though.
3sx fuel loop. Stock FPR.
This was on 91-Pump.


I believe it is version 3 build 6 btw.

I should also note what is going to go in it. I already have the parts, just wanted to get the break in finished and running correctly before adding this stuff.

RC 550cc's
Emanage Ultimate with Boomslang at Stage 2.5. I also have the injector adapter which I am assuming I just wired each of the 6 green to injector wires, but which ones? Red goes to 12v. I also have no idea how to tune with this. I have the Emanage MAP sensor and want to go speed density with no MAF. I think I am going to use a GM IAT. Also, I have the GM boost solenoid and hope to use Sub-Inj map to have a cheap EBC. IDK about this yet because I have heard good and bad about this.


I know I need to get a Wideband, but as of right now, I have no job. So I am assuming that everything is running ok. I feel very accomplished with this engine. This is the first one I have built for myself, let alone, to this degree of precision.

Edit 2: I fucking hate my upper AC/Alt pulley. I have nightmares of the whine it causes and the ladies that laugh at me.