Tein Flex for AWD with EDFC

**R/T93** · 10-09-2013, 08:42 PM

SOLD

First thing first, these will NOT work for FWD.

1000 plus shipping.

I have had these on the car since I bought it and they have been on it since well before that. They are in good shape, not blown, and the EDFC works (small wiring issue on a front strut, see below). They come with Eibach camber bolts. These give the struts adjust-ability for camber at the strut as the factory welded on eccentric cam follower is not on the TEIN mounting ears.

I wiped them down with degreaser. There are small paint chips on the green body housing and the anodized top hats arent scratched or bent at all, the anodizing looks good. Not new but good. There is paint missing on the INSIDE of the mounting ears on the fronts.

The colored wiring on the left is for 12v, ground, illumination, etc. The next connector in line is from the power harness to the EDFC controller. The 4 remaining wire bundles go to each strut, you have to snake them through the car/engine bay.

Rears

Fronts

EDFC boxes (you can see the bare wiring on one of the fronts, I have some 3 pin delphi waterproof connectors I am sending with these, as well. An easy wiring job.

The wiring issue

The Delphi connectors have all the pins and waterproof boots in the small plastic bag, there is a set of two connectors in that bag.

Controller

I have copied instructions for both the coil overs AND the EDFC.

925 shipped