NEW 3SX Fuel Sending Units and Fuel Kits

[SUTHNR]

After 2 years in development we have finally released our 3SX Fuel Pump Sending Units! These units define versatility in your fuel system - from STOCK to 1000+ hp! These kits include custom aluminum bulkheads that are basically the LAST sending unit you'll ever buy! They are set up with AN10 ports for feed and AN8 ports for return - meaning they can be adapted down to serve as a stock replacement unit on a stock SOHC or adapted to run however much fuel and power you are going for! The wiring is properly insulated and "putty'd" in place ensuring a safe seal for the electrical connections - no "nuts-n-nylon-washers" here! The hanger bracket accommodates all of the "smaller" pumps from Walbro, Aeromotive, and AEM. Or remove the bracket and the giant Fuelab Prodigy pumps directly attach to the sending unit allowing for up to their 1800hp rated 722 lph / 190 gph 42402 series pump!

Replacement Sending Unit Kits
3SX Custom Fuel Kits - BulkHead Sending Unit with Walbro or Aeromotive Stealth Pump - Drop-in Stock Replacement*-*Mitsubishi 3000GT*/*Dodge Stealth Parts

Complete Fuel Kits with Sending Unit
3SX Custom Fuel Kits - COMPLETE - BulkHead Sending Unit w/ Aeromotive Stealth Pump FueLab FPR Filter Lines Fittings Rails*-*Mitsubishi 3000GT*/*Dodge Stealth Parts

High-end kits using the high-volume FueLab Prodigy pumps will be listed shortly as well!

The 3SX Crew

[Greg E]

Looks great guys!

[audiofreek]

Good looking product well done guys

Sent from my GT-I9305 using Tapatalk 2

[mjannusch]

Is it possible to get these in the tank with two Walbro 400s attached?

[LeRoyDL]

How does the fuel level sending unit attach? Have any pics of one installed?

[SUTHNR]

Is it possible to get these in the tank with two Walbro 400s attached?

We are not offering it with plumbing for a twin pump setup, but you can get it without the pump and DIY the twin plumbing. We decided for big fuel demands to simply use the FueLab Prodigy pumps - those attach directly to the bottom of the hat with a AN10-ORB union. Then you can use the Fuelab electronic FPR that manages the pump. We'll be listing those within a week.

How does the fuel level sending unit attach? Have any pics of one installed?

The level unit attaches to the side just like it does to the factory hanger. Here's the setup with a single Walbro mocked up - this would be your stock-replacement setup (Kit BH-02) good for a bone-stock car or mild mods - up to the power levels a Walbro will support (550 injectors).



EricB