Long story short I need to adjust my alignment again. I am going to raise the back a hair while I am at it. I was wondering how you guys set up your ride height. Do you make it the same L/R? Make it the same all around?

What I initially did was measure the stock height then just lower those values by a set length. Doing it this way, one side was a little higher than the other. I figured this would compensate for a possibly uneven floor.

Also if anyone has it handy, what is the difference in track width from front to back? I think it is 10mm wider in the rear but want to make sure. Do you guys just measure from the string to the center cap of the wheel?

Thanks!