Hey any of you gearheads know the baseline preload for the wastegates?
Cheers-
Hey any of you gearheads know the baseline preload for the wastegates?
Cheers-
i would personally say stock wastegate springs are 6.5 psi. thats what it is on mine, and another friends car. mine has an electronic boost gauge, whereas my friends is mechanical. both 6.5psi.
but whats 1.5 psi between friends? not much. either way the stock wastegate spring is set for low boost.
rise and rise again until lambs become lions
There`s no documented pre-load or setup listed in the manual for the actuators, I go by feel. they need to be snug, probably 2mm of movement of the actuator rod from flapper closed should be about right when adjusting the rods.
GTO-TT, PTE 1200's, M20, Emanage Ultimate, OS Geiken R3C,
TD04-16g`s, Maf-t. 13g`s 12.4@115mph / 16g`s 12.5@117mph.
Thanks for the response guys-
Yes, the FSM's do leave you going by feel in a number of areas-
I did come across an old post by RobBeck stating a minimum 3 turns from zero preload, worked out to be about the 2mm.
3000gt.com 3000GT / Stealth International WWWboard Archive Jim's (RED3KGT) Reststop |
Team 3S 3000GT / Stealth / GTO Information daveblack.net |
Michigan 3S MInnesota 3S Wisconsin 3S Iowa, Nebraska, Kansas 3S |
North California 3000GT/Stealth United Society of 3S Owners 3000GT/Stealth/GTO Forums 3000GT/Stealth International |
3S National Gathering East Coast Gathering Upper Mid-West Gathering Blue Ridge Gathering |
Bookmarks