View Profile
View Forum Posts
View Forum Threads
Show All Albums
Private Message
View Articles
View Blog Entries
Haha. You guys do need to hang out in chat more
It was great to meet you, Bill! I'm glad I can say I helped, even if we wasted time looking for a bracket that didn't seem to exist, lol
Haha. You guys do need to hang out in chat more
It was great to meet you, Bill! I'm glad I can say I helped, even if we wasted time looking for a bracket that didn't seem to exist, lol
R135
╚╬╬╝
- 24
I'm sure it exists. Will find it when the engine is in...
Help them, for they know not that which they do not know!
CoopKill's Mistress Makeover Thread!
"Punk, Nutswinging, Small Time, Asshat, Monkey, Jerkoff, Loser that rides on other peoples accomplishments!" ..
I would also like to add that I HATE torquing the heads to 105lbs. It scares the crap out of me every time!
It was nice meeting you as well Kenny! Thanks for the help.
seriously? why does it scare you? 105 isn't THAT tight...
rise and rise again until lambs become lions
Originally Posted by futurevr4man
Because Bill has snapped a lot of bolts lately.
Ported heads, IPS 2mm oversized valves, Delta 264/272 cams, 3SX High rev valve springs, 3SX cam gears,
Merkel 6g72 3.5L BILLET crank stroker (going in this summer), 3sx poly motor mounts
IPS EvoIII turbo kit, HKS SSQV bov, ETS anodized FMIC, AEM intake filters, Tanabe Turbo Back Concept G Blue Exhaust,
HKS DLI, Ultra spark plug wires, Denso iridium IK24 spark plugs,
JSPEC trans, Ultimate Performance short throw shifter, Spec carbon twin disk clutch, PST aluminum 2 piece drive shaft,
Denso Supra fuel pump, RC 750cc fuel injectors, AEM Fuel pressure regulator,
AEM wideband & boost gauge, AEM EMS in speed density,
Addco sway bars, DBA 4000 drilled & slotted rotors, Enkei PF01 18x9 +45, BFGoodrich g-froce KDW 245/40/R18
It feels like it will strip, or snap every time. Drilling out head bolts is not a fun time.
Mine are only set to 100 if that is any consolation. I've never pushed coolant. No head lift fixes either.
Jeff
A little closer. Unfortunately I must have pinched the rear valve cover gasket while putting it on last time. New set on order! Cleaned up thw water jacket, and added disappear paint.
Throw some gears on the rear, and she is ready. Need to run some wires differently for the gauges before it goes in.
Sent from the Man Cave!
*\( ^o^ )/*
Last edited by CoopKill; 06-12-2014 at 09:08 PM.
Maybe change the damper if its old
VR4tune stopped by!
Sent from the Man Cave!
*\( ^o^ )/*
Posting Permissions
|
3000gt.com 3000GT / Stealth International WWWboard Archive Jim's (RED3KGT) Reststop |
|
Team 3S 3000GT / Stealth / GTO Information daveblack.net |
|
Michigan 3S MInnesota 3S Wisconsin 3S Iowa, Nebraska, Kansas 3S |
North California 3000GT/Stealth United Society of 3S Owners 3000GT/Stealth/GTO Forums 3000GT/Stealth International |
|
3S National Gathering East Coast Gathering Upper Mid-West Gathering Blue Ridge Gathering |
Reply With Quote
Bookmarks