I need some help trying to figure out the proper fuel setup to top off my build.
Here's what I'm working with:
92 VR4 18 spline
4-bolt block
4340 H-beam Forged rods
CP pistons 0.030" over 8:1 CR
DR Stage 3 heads w/ high rev/lift springs
274 cams
Solid lifters
Adjustable cam gears
TD04 19T Turbos
JDM Throttle body
Stock upper and lower intake
Stock exhaust manifolds and O2 housings
3" down pipe
Borla Catback w/ 3" test pipe
Stock Sidemounts and IC piping (for now)
Here's my dilemma;
I was really wanting to run E85, on a speed density setup using an AEM EMS, but I am getting ready to relocate to a small town in the Upper Peninsula of MI and the closest station that sells E85 is about 80 miles away. I also have NO experience tuning and probably don't have anyone near that could assist me. This will not be my DD, but I will cruise it alot during the summer months. I need a setup that I can drive several hundred miles if I wanted to. I don't want to push everything at 110% either. I would be happy with 425 ~ 450 AWHP. Not going to have much compitition to take out
What would be your recommendations on the following:
1. Fuel choice
2. Injector size
3. Fuel pump
4. Engine / Fuel management system
Bookmarks