I need to replace both of mine. What size are they and how do I take them off?
Printable View
I need to replace both of mine. What size are they and how do I take them off?
http://stealth316.com/2-oxygensensor.htm
I was able to get the front off using an open end wrench from underneath without removing anything else.
Thanks for that. The size is 7/8" on the hex of the sensor.
Ya almost all 02 sensors including the AEM ones are 7/8. Some of the autozone type non-OEM replacements are wierd sizes though.
I can not get my front sensor to come loose, I am about to strip it, what do you guys do?
Is there no way for you to impact it? Hit the wrench with a hammer? You might need to try that 50/50 ATF/Acetone mix and tell us how it works.
I need to use a flared wrench,
you trying with an open end wrench? since you are getting rid of them cut off the connector if you cant fit the wrench over it, and use the closed end. Otherwise try and pick up an 02 sensor socket form a parts store, they work well for breaking them loose.
Yeah I just bought an o2 sensor socket and pb blaster to see if this does the trick. Thanks for the help guys..3sgto ftw.
I used the autozone rent a tool O2 sensor remover tool. Worked great!
I replaced my o2 sensors with these:
http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWNX%3AIT
I purchased a long 7/8" combination open/closed end wrench from sears (craftsmen). I may have broke it by adding a large adjustable wrench to the closed end. I also cut the wires, spinning it was a pain with the plug on it. Was still a pain as its tight, but DOABLE. I also picked up O2 sensor socket from Harbor Freight for under 5 bucks, nice for the rear bank o2.Quote:
Originally Posted by Austin@STM
Got replacement OEM from RockAuto, but Mean Green's solution is much better $$$$
Well I got them out, was a huge pain in my arse. The rear o2 sensor was cross threaded making it a lot longer then I expected. Front was a lot easier after soaking it in PB Blaster and let it sit for 3 hours. I HIGHLY RECCOMMEND 22MM WRENCHES! A lot less likely to strip the o2 sensor which made it so much more difficult, I am just glad I did not have to torch the housings.
I used the 02 sensor remover as well, but found that heating them up first with a torch worked really nice. After you take the heat away, wait a few minutes and then try and tighten it! This breaks it free and then everyone of mine came right out no problem.
Just replace front and rear on my fiances car to pass smog. Used the Auto Zone rental [$25.00, refunded when you return it] crows foot attachments.
Once the front one is loose you can put an open end wrench on it from underneath like Atrosity says.
If you use ARP Ultra Torque assembly lube on the threads it makes them real easy to install, plus it handles high temperatures and has anti-seize properties. Love mine.